Overview
The Pro Comp EXPK4062T, also sold as K4062T, is a 6-inch Stage II suspension lift kit with PRO-X shocks for the 1990–1996 Ford Bronco. The rear lift is an Add-A-Leaf, and the kit fits that Bronco range directly.
An Add-A-Leaf adds one leaf to the rear leaf spring pack rather than replacing the springs. The lift height is 6 inches, with a range of 6 to 7 inches for this Stage II kit.
Key features
- 6-inch Stage II lift with a 6–7 inch lift height range
- Add-A-Leaf rear lift component
- PRO-X front and rear shocks, included
- Direct fit to the listed 1990–1996 Bronco trims
Add-A-Leaf considerations
An extra leaf raises the rear by adding to the spring pack, so the leaf spring’s rate and the way it carries load both change. On a Bronco that sees trail use, this can make the rear feel firmer when unloaded. Shock and bump stop clearance should be checked as well, since the rear sits at a new height.
The pinion angle often shifts with a rear lift, which can cause driveline vibration if it is not checked. Measuring the angle after installation and correcting it where needed helps keep the driveline smooth at speed.
Leaf packs can take a set over time, and clamp bolts can loosen on rough trails. Look for cracked leaves, worn spring bushings and shifted clamps during routine service, and replace worn spring parts before they affect alignment.
- Measure pinion angle after the install
- Inspect spring bushings and shackle bolts
- Check bump stop clearance at full compression
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | EXPK4062T (K4062T) |
| Kit type | Lift kit, complete suspension system |
| Kit stage | Stage 2 |
| Lift height | 6 inches, with a lift height range of 6–7 inches |
| Rear lift method | Add-A-Leaf |
| Rear lift component | Add-A-Leaf |
| Front shocks | PRO-X |
| Rear shocks | PRO-X |
| Shocks included | Yes |
| Fitment type | Direct fit |
Vehicle fitment
The kit fits the 1990–1996 Ford Bronco in the Custom, Eddie Bauer, XL, XLT, XLT Lariat, XLT Nite and XLT Sport trims.
Only the 1990–1996 Bronco is listed, so other Bronco generations and the Ford F-150 are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Add-A-Leaf lifts change the rear spring rate and the pinion angle, so check the driveline angles after the install. An alignment is also needed once the truck sits at its new height.
What’s included
The kit includes PRO-X shocks for the front and rear. The Add-A-Leaf is the rear lift component, and no full parts list is given for this part number.













