Overview
The Pro Comp 63153 is a 3 inch rear lift block kit with a U-bolt kit, made to achieve a rear lift on a leaf spring equipped vehicle. Pro Comp says its tapered lift blocks improve and retain the vehicle’s driveshaft angles.
The kit includes two rear lift blocks, four U-bolts, eight thick flat washers and eight U-bolt nuts. No vehicle is named for the kit, so match the blocks and U-bolts to your rear axle and spring before ordering.
Key features
- 3 inch rear lift height
- Tapered lift blocks
- Four U-bolts
- Eight thick flat washers
- Eight U-bolt nuts
- Designed for leaf spring vehicles
Driveshaft angle and leaf springs
Raising the rear of a leaf spring vehicle changes the angle of the driveshaft. A steep driveshaft angle can cause vibration, wear on the U-joints and faster wear on the transmission or transfer case output. Tapered lift blocks are designed to limit that change, but the angle should still be measured after the install, especially if the vehicle carries heavy loads or runs at highway speed for long periods.
Leaf spring rear axles also depend on the U-bolts holding the axle to the spring, so the hardware should be checked regularly. Look for loose nuts, shifting axle position or any clicking from the spring pack. If the vehicle is used off road, inspect the U-joints and the driveshaft yoke after rough trails, since those parts take the most stress when the angle is changed.
- Measure driveshaft angle after the lift
- Inspect U-joints after rough use
- Watch for axle shift on the springs
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 63153 |
| UPC | 614901022438 |
| Lift height | 3 inch |
| Lift blocks | 2, tapered |
| U-bolts | 4 |
| Thick flat washers | 8 |
| U-bolt nuts | 8 |
| Position | Rear |
| Suspension type | Leaf spring |
Vehicle fitment
No vehicle is named for this kit. Fit depends on the rear axle and leaf spring arrangement of your truck, so check those before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The tapered blocks are built to retain driveshaft angles, so measure the driveshaft angle after the rear is lifted to confirm it is still within range.
What’s included
Two rear lift blocks, four U-bolts, eight thick flat washers and eight U-bolt nuts.






