Overview
The Pro Comp 58100 is listed under the title “1 Inch Rear Block With U-Bolt Kit.” The item description, however, describes a heavy-duty front trac bar for Jeeps with a Johnny Joint pre-welded to one end, so the contents should be confirmed before ordering.
The bar keeps the front axle centered under the Jeep. It lengthens the trac bar, reduces bump steer and raises the trac bar to match the drag link on a vehicle with high steer. It is used with the axle-side and frame-side trac bar mounts.
The bar must be cut to length before installation. Measure the mounting points on your truck first and confirm the finished length before cutting.
Key features
- Heavy-duty trac bar design, per the item description
- Johnny Joint pre-welded on one end
- Designed to lengthen the trac bar and reduce bump steer
- Suited to hydro-assist or full hydraulic steering, per the item description
Trac bar geometry and joints
A trac bar links the axle to the frame so the axle stays centered under the vehicle as the suspension moves. When the bar is too short, too low or misaligned with the drag link, the axle can steer the truck through bump steer. Adjusting bar length and height is one way to bring the steering geometry closer to correct, and many trucks with raised suspension need that correction after a lift.
Joints carry the load at both ends of the bar. Heim rod ends and Johnny Joints wear with use, so check for play, binding, grease leaks and torn boots. Any movement in a joint shows up as wander or a loose feel at the steering wheel. Replacing worn joints together with the bar keeps the geometry consistent, and the steering and alignment should be checked after any change.
- Inspect joint boots for tears
- Check for play at both ends of the bar
- Recheck toe after any length change
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 58100 |
| UPC | 614901216172 |
| Title | 1 inch rear block with U-bolt kit |
| Joint | Johnny Joint pre-welded on one end |
Vehicle fitment
It is intended for Jeeps with a high steer setup. Confirm fit for your vehicle’s year, model and trim before ordering.
It is not recommended with stock crossover steering linkages. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The bar must be cut to length and a threaded bung welded in for the Heim rod end on the axle side, so it is not a bolt-on part. Check the mounts before welding, and have the steering and alignment checked after installation.
What’s included
One heavy-duty Jeep trac bar with a pre-welded Johnny Joint.









