Overview
The Pro Comp 57589 is a rear lift block kit from Pro Comp Suspension that raises a leaf spring vehicle by 3.5 inches at the rear. The kit combines tapered cast iron riser blocks with the U-bolts and hardware needed to mount them.
The tapered blocks help keep driveshaft angles in better shape once the rear is raised.
Key features
- 3.5 inch rear lift
- Tapered cast iron riser blocks
- Complete U-bolt hardware set
- Heavy duty flat washers and hi-nuts included
Driveshaft angle basics
Driveshaft angle matters most at the two universal joints, where a sharp angle can cause vibration and early joint wear. Raising the rear changes that angle, and the change grows with the height of the lift. A tapered riser is meant to reduce the change at the joints, but the rest of the driveline still needs a check after the lift is set.
Measure the angles with the vehicle at its normal load and compare the front and rear joint readings. If the joints run at very different angles, the driveline may need a further correction. Check the joint bolts and the yoke for wear during service, and listen for new vibration on the highway, since those are early signs the angle needs attention.
Specifications
| Brand | Pro Comp Suspension |
|---|---|
| Part number | 57589 |
| UPC | 614901111231 |
| Type | Rear block with U-bolt kit |
| Lift height | 3.5 in |
| Block material | Cast iron |
| Block shape | Tapered |
| Hardware | 4 U-bolts, 8 heavy duty flat washers, 8 hi-nuts |
Vehicle fitment
Kit fit depends on your rear axle and spring pack, so confirm both before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The blocks mount on the rear leaf springs only, with the supplied U-bolts. Keep the blocks oriented as the kit is supplied, since the taper is designed for driveshaft angles.
What’s included
The kit includes 2 cast iron riser blocks, 4 U-bolts, 8 heavy duty flat washers and 8 hi-nuts, packed in a box.







