Overview
The Power Stop AR8772XPR is a rear slotted and cross-drilled brake rotor made for the 2003–2008 Dodge Ram 2500 and Ram 3500. It replaces the original rear disc on those trucks.
The AR8772XPR is a rear rotor with a slotted and cross-drilled face, offered in place of a plain disc. It is made for the 2003–2008 Dodge Ram 2500 and Ram 3500, so confirm fit for your truck before ordering.
Rotors are wear parts: the pad surface thins and can warp or score over time. Replacing them restores a flat, true surface for the pads.
Key features
- Slotted and cross-drilled rear rotor
- Direct fit for the listed vehicles
- Coated rotor
- Rounded slots that sweep water, gas and dust from the pad contact patch
- Silver zinc plated to shield against rust during normal operation
- Cross-drilled holes that Power Stop says keep rotors up to 180°F cooler
- Mill balanced
- Looks good behind custom or factory wheels
- Tru-Cast precision machining
Wheel hardware and rotor swaps
Changing a rear rotor touches the hub, wheel studs and lug nuts, so those parts deserve attention during the job. Clean the hub face so the disc sits flat, and check that the studs are straight and undamaged before the wheel goes back on.
Rotor run-out affects pedal feel. A disc mounted over rust or debris can wobble, so tighten the lug nuts in a star pattern and recheck them after the first drive. Test the brakes at low speed before returning to normal use.
Rear rotors often wear more slowly than fronts, so inspect the pads and caliper slide pins at the same time. Sticking pins can make a new rotor wear unevenly even when the disc itself is sound. Replace worn pads with pads suited to the rotor type.
- Clean the hub face and mounting surface
- Check wheel studs for damage
- Inspect caliper slide pins
- Retorque lug nuts after the first drive
Specifications
| Brand | Power Stop |
|---|---|
| Part number | AR8772XPR |
| UPC | 792088554338 |
| Product type | Slotted and cross-drilled disc brake rotor |
| Position | Rear |
| Fit type | Direct fit |
| Coating | Rotors coated |
| Casting | G3000 grade cast |
| Plating | Silver zinc |
| Machining | Tru-Cast precision machined |
| Rotor run-out | Within 0.0015 |
| DTV tolerance | Within 0.005 |
| Balance | Mill balanced |
Vehicle fitment
It fits the following vehicles and trims: 2003–2008 Dodge Ram 2500 (Laramie, Power Wagon, SLT, ST, SXT, Sport, TRX4); 2003–2008 Dodge Ram 3500 (Laramie, SLT, ST, SXT, Sport, TRX4).
Compare the diameter, thickness and bolt pattern with the rotor you are removing, then install the new one.
Fit is for 2003–2008 Ram 2500 and Ram 3500 models; Ram 1500 and later heavy-duty years fall outside this application. Make sure your year, model and trim match before ordering.
Installation notes
Re-check the wheel lug nuts after the first drive following the work.
What’s included
The AR8772XPR is a Power Stop brake rotor sold as the rotor only.
Not included: Pads, calipers, wheel studs and fasteners are separate items.









