Overview
The Power Stop AR8732XPR is a rear slotted and cross-drilled brake rotor for the 1994–1998 Jeep Grand Cherokee (ZJ). Drilled holes help the rotor shed heat during hard stops, and slots clear gas, dust and water from between the pad and the rotor.
It suits owners of the 1994–1998 Jeep Grand Cherokee (ZJ) who want a rear rotor with a slotted and cross drilled face rather than a plain disc. Match your vehicle’s year, model and trim before you order.
Cross-drilled holes give heat and gas somewhere to go, and slots wipe the pad surface as the rotor turns. The two features are often combined on rotors meant for harder-than-usual braking.
Key features
- Slotted and cross-drilled rear rotor
- Direct fit for the listed vehicles
- Tru-Cast precision machining
- Designed to reduce brake fade
- Beveled, precision-drilled holes to help hold temperatures down in extreme braking
- G3000 grade cast
- Slots keep a clear contact patch between pad and rotor
- Rotor run-out within 0.0015 and DTV tolerance within 0.005
- Coated rotor
Rear rotor replacement tips
Rear brakes usually do less work than the front, but they still carry load and heat during every stop. A rear rotor that is worn or warped can cause vibration and uneven pad wear, so inspect the face and hub surface each time the pads are serviced.
The parking brake on many rear setups is tied to the rear rotor and shoes or caliper, so check that the hardware moves freely after installation. Clean the hub, and keep grease off the friction surface so the pads grip evenly.
Rotors wear unevenly when only one side is replaced, so match the left and right sides across the rear axle. Bed in new pads gradually and avoid heavy braking until the system has cooled and settled.
- Check parking brake operation after installing
- Clean and inspect the hub face
- Replace rotors in pairs across the axle
- Keep grease off the friction surface
Specifications
| Brand | Power Stop |
|---|---|
| Part number | AR8732XPR |
| UPC | 792088553997 |
| Product type | Slotted and cross-drilled disc brake rotor |
| Position | Rear |
| Fit type | Direct fit |
| Coating | Rotors coated |
| Casting | G3000 grade cast |
| Plating | Silver zinc |
| Machining | Tru-Cast precision machined |
| Rotor run-out | Within 0.0015 |
| DTV tolerance | Within 0.005 |
| Balance | Mill balanced |
Vehicle fitment
It fits the 1994–1998 Jeep Grand Cherokee (ZJ) in the 5.9 Limited, Laredo, Limited, Orvis, SE and TSi trims.
Rotor diameter, thickness, bolt pattern and weight should be compared with the part being replaced before purchase.
Only the ZJ generation (1994–1998) is listed; the 1999–2004 Grand Cherokee (WJ) is a different generation and is not covered by this part number. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Rotors are normally replaced in pairs across an axle so the left and right sides wear evenly.
What’s included
This is a single brake rotor, and no extra parts are included.
Not included: No brake pads or caliper hardware are listed with the rotor, so they would come separately.









