Overview
The Power Stop AR85116XPR is a rear slotted and cross-drilled brake rotor for the 2005–2012 Ford F-250 Super Duty and F-350 Super Duty.
This Evolution rotor pairs slotting with cross drilling. The slots clear gas, dust and water from the pad contact patch, and beveled, precision-drilled holes help keep rotor temperatures down under hard braking.
Key features
- Drilled holes aimed at lower rotor temperatures, rated by Power Stop at up to 180°F cooler
- Slotted face that clears gas, water and dust from the pad contact area
- Made with Power Stop’s Tru-Cast process and precision machining
- Rotor runout held to 0.0015, with DTV tolerance within 0.005
- Evolution series rotors are mill balanced
- Silver zinc plated to shield against rust
- Cast to G3000 grade
- Helps reduce brake fade
- The drilled and slotted face suits both factory and custom wheels.
Before you replace rotors
Rotors and pads wear together, so replacing one without checking the other can leave braking uneven and shorten the life of the new part. While the wheel is off, inspect the pads, calipers, hoses and brake lines, then clean the hub face so the new rotor sits flat against it. A rust ring or debris on the hub can cause runout that shows up later as pedal pulsation.
Drilled and slotted faces shed more debris and heat than plain rotors, so pad choice matters. Pick pads designed for this kind of disc and bed them in with a series of moderate stops that build an even transfer layer on the rotor surface. Avoid heavy stops during the first trips after installation, and let the brakes cool between hard runs.
- Cracks that start at the drilled holes
- Deep grooves or a raised lip on the outer edge
- Pulsing through the pedal during light braking
Specifications
| Brand | Power Stop |
|---|---|
| Part number | AR85116XPR |
| UPC | 792088552549 |
| Product line | Power Stop Evolution |
| Position | Rear |
| Rotor type | Slotted and cross drilled |
| Material | G3000 grade cast |
| Finish | Silver zinc plated |
| Runout | Within 0.0015 |
| DTV tolerance | Within 0.005 |
| Balance | Mill balanced |
| Coating | Coated |
| Cooling holes | Beveled, precision-drilled cross holes; Power Stop says they keep rotors up to 180°F cooler |
| Slots | Rounded slots that sweep a clear contact patch between pad and rotor |
| Manufacturing | Tru-Cast technology, precision machined |
| Fade | The rotor is designed to reduce fade. |
| Appearance | The rotor face is designed to look good behind custom or factory wheels. |
| Plating note | All drilled and slotted rotors except hub and rotor assemblies are silver zinc plated |
| Fit | Direct fit |
Vehicle fitment
The AR85116XPR is a rear rotor for the 2005–2012 Ford F-250 Super Duty and F-350 Super Duty, in the Cabela’s, FX4, King Ranch, Lariat, XL and XLT trims. Super Duty trucks from 2013 onward and F-450 models are not covered, so match your vehicle’s year, model and trim before buying.
Listed vehicles:
- 2005–2012 Ford F-250 Super Duty (Cabela’s, FX4, King Ranch, Lariat, XL, XLT)
- 2005–2012 Ford F-350 Super Duty (Cabela’s, FX4, King Ranch, Lariat, XL, XLT)
Super Duty trucks from 2013 onward and F-450 models are not part of this list. Confirm your vehicle’s year, model and trim before ordering.









