Overview
The Power Stop AR8567XPR is a front slotted and cross-drilled brake rotor for the 1999 Ford F-250 Super Duty and F-350 Super Duty. The AR8567XPR is made for the front axle, uses cross-drilled holes together with slots, and arrives coated.
Mill balancing and Tru-Cast precision machining are part of how Power Stop builds its Evolution rotors, which use drilled holes for cooling and slots to clear gas and dust.
The rounded slot pattern, beveled drill holes and G3000 grade casting are designed for front brakes, and the rotor is machined to tight run out and DTV limits.
Key features
- Rounded slots clear water, gas and dust
- Cross-drilled holes for cooling
- Silver zinc plating resists rust
- G3000 grade casting
- Tru-Cast precision machining
- Beveled, precision-drilled holes
- Reduces brake fade
- Evolution rotor, mill balanced
- Run out within 0.0015, DTV tolerance within 0.005
- Direct-fit design
Pad choice and bedding in
Drilled and slotted rotors work best with pads that are matched to them and in good condition. Pads that are worn or glazed can reduce the rotor’s benefit, and a rotor with heavy cracking at the holes should be replaced rather than reused. Choose a pad compound suited to towing and heavy loads if the truck is used that way.
After installation, bed in the pads with a series of controlled stops from moderate speed, which transfers an even layer of friction material to the rotor face. Avoid hard stops right after the work until the brakes feel consistent. Check the caliper slides and pad hardware for free movement during the same job.
- Cracks radiating from the drill holes
- Glazed or uneven pad surface
- Caliper slides that stick
- Pulsing pedal after a hard stop
Specifications
| Brand | Power Stop |
|---|---|
| Part number | AR8567XPR |
| UPC | 792088553003 |
| Type | Slotted and cross drilled |
| Position | Front |
| Coating | Coated |
| Finish | Silver zinc plated |
| Material | G3000 grade casting |
| Machining | Tru-Cast precision machined, mill balanced |
| Tolerances | Run out within 0.0015; DTV within 0.005 |
| Drill holes | Beveled and precision drilled |
| Slots | Rounded slots sweep water, gas and dust |
| Cooling | The drilled holes are designed to keep the rotor up to 180°F cooler. |
| Line | Evolution |
| Fit | Direct fit |
Vehicle fitment
It fits these vehicles: 1999 Ford F-250 Super Duty (Lariat, XL, XLT) and 1999 Ford F-350 Super Duty (Lariat, XL, XLT).
It is made for the 1999 model year only. 2000 and later Super Duty trucks and the rear axle are outside its fit. Check the year, model and trim against your truck before ordering.
Installation notes
Install the AR8567XPR on the front axle only, and plan on fresh brake pads, since a drilled and slotted face works with pads that are in good condition.









