Overview
The Power Stop AR8598XPR is a rear slotted and cross-drilled brake rotor for the 2004–2011 Ford F-150 and the 2006–2008 Lincoln Mark LT. The AR8598XPR is made for the rear axle, uses cross-drilled holes together with slots, and arrives coated.
The rotor uses a G3000 grade casting with a silver zinc plated finish. Beveled holes are drilled to help keep temperatures down during extreme braking.
The cross-drilled holes and slots work together on the rear axle, helping to reduce fade and resist rust during normal use.
Key features
- Cross-drilled holes for cooling
- Rounded slots clear water, gas and dust
- Silver zinc plating resists rust
- G3000 grade casting
- Tru-Cast precision machining
- Beveled, precision-drilled holes
- Reduces brake fade
- Evolution rotor, mill balanced
- Run out within 0.0015, DTV tolerance within 0.005
- Direct-fit design
Rear brake maintenance
Rear rotors usually do less work than fronts, but they still carry a large share of braking on loaded trucks. They often wear unevenly because the parking brake and the rear hubs are used differently from the front. Checking rear pads and rotors at the same time as the fronts keeps the whole braking system balanced and avoids surprises later.
Drilled and slotted faces can show more pad dust than smooth faces, and that dust is normal. Debris trapped in the slots and holes should be cleared occasionally with a soft brush. Look for cracks that start at the holes, since they signal stress and call for replacement. Check the hub face for rust before mounting the new part, because a dirty hub is a common cause of runout.
- Inspect rotor edges for a lip that signals uneven wear
- Clean the hub face and lug studs before installing
- Check rear brake lines and hoses during service
- Verify wheel bearings have no play
Specifications
| Brand | Power Stop |
|---|---|
| Part number | AR8598XPR |
| UPC | 792088553294 |
| Type | Slotted and cross drilled |
| Position | Rear |
| Coating | Coated |
| Finish | Silver zinc plated |
| Material | G3000 grade casting |
| Machining | Tru-Cast precision machined, mill balanced |
| Tolerances | Run out within 0.0015; DTV within 0.005 |
| Drill holes | Beveled and precision drilled |
| Slots | Rounded slots sweep water, gas and dust |
| Cooling | The holes keep rotors up to 180°F cooler. |
| Line | Evolution |
| Fit | Direct fit |
Vehicle fitment
It fits 2004–2011 Ford F-150 (FX2, FX4, Harley-Davidson Edition, King Ranch, Lariat, Lariat Limited, Limited, Platinum, STX, SVT Raptor, THE 60TH ANNIVERSARY EDITION, XL, XLT) and 2006–2008 Lincoln Mark LT (Base), on the rear axle.
The AR8598XPR is a rear rotor, and it does not cover F-150 years after 2011. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Install the AR8598XPR on the rear axle only, and plan on fresh brake pads, since a drilled and slotted face works with pads that are in good condition.









