Overview
The Power Stop AR8583XPR is a front slotted and cross-drilled brake rotor for the 2000–2003 Ford F-150, the 2004 F-150 Heritage and the 2002 Lincoln Blackwood. The AR8583XPR is made for the front axle, uses cross-drilled holes together with slots, and arrives coated.
The drilled holes help keep rotors cooler, and the rounded slots sweep water, gas and dust away so the pad keeps a clear contact patch.
In Power Stop’s own wording, the AR8583XPR belongs to its Evolution line, where every rotor is mill balanced and the drilled and slotted face is meant to look good behind custom or factory wheels.
Key features
- Cross-drilled holes for cooling
- Rounded slots clear water, gas and dust
- Silver zinc plating resists rust
- G3000 grade casting
- Tru-Cast precision machining
- Beveled, precision-drilled holes
- Reduces brake fade
- Evolution rotor, mill balanced
- Run out within 0.0015, DTV tolerance within 0.005
- Direct-fit design
Front rotor and pad pairing
Front rotors on pickups share the job of stopping heavy loads, and a rotor’s performance depends on the pads it runs against. Pads that are too hard can glaze a drilled and slotted face, while pads that are too soft may wear quickly under repeated hard stops. Cold, wet weather can also change how quickly a pad grips a new face, so choose pads designed for the rotor and the driving you do.
Because the holes and slots keep moving debris away from the contact area, the pad surface can wear differently than on a plain rotor. Inspect the pads at each brake job and replace them as a set on both sides. Clean the hub before installation and tighten the wheel lug nuts to specification.
- Use pads rated for the rotor’s intended use
- Check pad thickness on both wheels
- Look for glazing that makes the pedal feel firm but weak
Specifications
| Brand | Power Stop |
|---|---|
| Part number | AR8583XPR |
| UPC | 792088553140 |
| Type | Slotted and cross drilled |
| Position | Front |
| Coating | Coated |
| Finish | Silver zinc plated |
| Material | G3000 grade casting |
| Machining | Tru-Cast precision machined, mill balanced |
| Tolerances | Run out within 0.0015; DTV within 0.005 |
| Drill holes | Beveled and precision drilled |
| Slots | Rounded slots sweep water, gas and dust |
| Cooling | Cross drilling helps keep rotors up to 180°F cooler. |
| Line | Evolution |
| Fit | Direct fit |
Vehicle fitment
It fits 2000–2003 Ford F-150 in the Base, King Ranch, Lariat, XL and XLT trims, 2004 F-150 Heritage in the XL and XLT trims, and 2002 Lincoln Blackwood in the Base trim.
It does not cover the 2004 F-150 outside the Heritage, and it does not fit newer F-150 generations. Check your year, model and trim before you order.
Installation notes
Install the AR8583XPR on the front axle only, and plan on fresh brake pads, since a drilled and slotted face works with pads that are in good condition.









