Overview
The Poison Spyder 15-04-043 is a set of Crusher Corners for the stretched Jeep Wrangler LJ, sold under the Daddy Longlegs name. The corners require a 4-inch rear wheelbase stretch and are sized for the stretched LJ. They allow up to a 40-inch tire.
The corners are designed to match the stretched LJ and give wheel well to wheel well rocker protection when used with the Daddy Longlegs special edition Rocker Knockers. The large wheel opening is moved as high as possible for extreme clearance. They are made to pair with the front DeFender XC fenders, and the design allows extreme articulation while keeping a low center of gravity.
The corners are formed from 3/16-inch steel plate, and the rear flares are weld-on. The armor was custom designed for this stretched LJ, so the corners are not intended for a standard wheelbase LJ without the stretch.
Key features
- Built for a 4-inch rear wheelbase stretch on the LJ
- Allows up to a 40-inch tire
- Wheel well to wheel well rocker protection with the Rocker Knockers
- Extra high wheel opening for extreme clearance
- Formed from 3/16-inch steel plate, bare steel
- Weld-on flares
Stretched LJ setup notes
A longer wheelbase changes how the rear corners sit relative to the tire, so the stretch and the armor work together. Once the wheelbase is extended, check the rear driveshaft angle, brake line length and fuel system routing, since these can shift when the rear body moves. Corners built for the stretch only fit correctly when that stretch is complete.
Tire size and articulation matter for rear armor. Larger tires need careful checks at full compression, especially near the rear of the wheel opening. A wide wheel opening leaves less material to block mud from being thrown, so a splash guard or flap may be worth considering. Rocker coverage also depends on the sill height and the condition of the door sill.
- Confirm the wheelbase stretch is finished before fitting
- Check brake and fuel lines after the rear body moves
- Test tire clearance at full compression
- Inspect welds on the weld-on flares after trail use
- Coat cut edges before painting
Specifications
| Brand | Poison Spyder Customs |
|---|---|
| Part number | 15-04-043 |
| UPC | 614901736380 |
| Corner type | Full |
| Material | 3/16-inch steel plate |
| Wheelbase requirement | 4-inch rear wheelbase stretch |
| Maximum tire | Up to a 40-inch tire |
| Flares | 3-inch wide, weld-on |
| Finish | Bare steel |
| Installation type | Cutting or drilling required |
| Fitment type | Direct fit |
Vehicle fitment
These corners are made for the stretched Jeep Wrangler LJ, which covers the 2004–2006 model years.
Verify year, model and trim for your LJ before ordering. They require the 4-inch rear wheelbase stretch and are made for the stretched LJ rather than the Wrangler TJ or JK.
Installation notes
Installation requires cutting or drilling and welding of the weld-on flares. The 4-inch rear wheelbase stretch must be in place before the corners go on. Paint or powder coat the bare steel after fitting.
What’s included
The corners are supplied in bare steel with weld-on flares.
Not included: the 4-inch rear wheelbase stretch, the Daddy Longlegs special edition Rocker Knockers, which Poison Spyder pairs with the corners for wheel well to wheel well protection, and paint or powder coating.









