Overview
The Omix-Ada 18038.03 is a front lower ball joint, part number OAI18038.03, for the Jeep Liberty KJ. It fits the 2002–2005 Liberty in the Limited, Renegade, Rocky Mountain Edition and Sport versions.
It is a direct OE replacement built to original specifications. It is a lower joint on the Dana 30A front axle of the KJ and is lubeable.
Key features
- Lower position for the front suspension
- Fits the driver or passenger side
- Lubeable joint
- Built to original specifications
Ball joint wear and service
A lower ball joint carries the weight of the front end and lets the knuckle pivot as the wheel steers and travels over bumps. Wear shows up as clunking over bumps, looseness at the wheel, or uneven tire wear on the tread edges. Because the lower joint takes most of the load, a worn one should be replaced before it damages the knuckle or the control arm.
On a lubeable joint, a grease fitting lets the seal be serviced. Regular greasing reduces wear, but a torn boot or play in the joint means replacement is the safer choice. When replacing a lower joint, check the upper joint, tie rod ends and steering components for wear as well, since they are often inspected together on a front end.
- Check boot condition before greasing
- Inspect for play with the wheel off the ground
- Replace worn joints as a matched pair on the same axle when practical
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | OAI18038.03 |
| Position | Front lower, driver or passenger side |
| Axle location | Front |
| Axle type | Dana 30A KJ |
| Lubeable | Yes |
Vehicle fitment
It is a direct-fit part for the 2002–2005 Jeep Liberty (KJ) in the Limited, Renegade, Rocky Mountain Edition and Sport versions.
Other Liberty years, and the later Liberty KK generation, are not on this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One front lower ball joint, part OAI18038.03.









