Overview
The Omix-Ada 12011.13 is a front left seat frame for the driver front position of the 1949-1953 Jeep Willys CJ-3 chassis. It is a direct OE replacement frame built to original specifications by Omix-Ada.
Omix-Ada provides a limited five year manufacturer warranty on the frame. Confirm the frame’s mounting points match your seat before installing.
Key features
- Direct OE replacement for the original seat frame
- Built to original specifications by Omix-Ada
- Driver front position, front left
- Direct fit
- Limited five year manufacturer warranty
Seat frame installation basics
A seat frame carries the seat and occupant, so it has to sit square and bolt down firmly to the floor mounting points. Before lifting the old frame out, photograph the bolt locations and note any spacers or washers. Clean the mounting surfaces of rust and debris so the new frame seats flat.
Older frames often show wear at the pivot points and rails, so inspect those areas on the old unit before removing it. Cracked welds, bent rails or loose slides are signs the frame needs replacing. Lubricate moving parts lightly and check that the seat locks in each position before you drive the vehicle.
- Torque bolts evenly and recheck them after the first drive
- Replace any worn or rusted hardware instead of reusing it
- Test the seat’s travel and locking positions before use
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 12011.13 |
| UPC | 804314066833 |
| Location | Driver front |
| Position | Front left |
| Fitment type | Direct fit |
Vehicle fitment
The manufacturer fitment list covers the 1949-1953 Jeep Willys CJ-3 chassis.
Other Jeep generations are not on this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Check the package contents, including any hardware or brackets, against your installation before starting.









