Overview
The Omix-Ada 16910.01 is a pilot bushing for 4 cylinder Jeep and Willys vehicles. A pilot bushing supports the front of the transmission input shaft inside the crankshaft. It is built to original specifications as a direct OE replacement.
It fits Willys and early CJ models, DJ and Dispatcher, FC trucks, Jeepster, Commando and Utility models from 1941 to 1971.
Key features
- Direct OE replacement built to original specifications
- Fits 4 cylinder engine applications
- Covers Willys-era, CJ, DJ and FC models.
- Limited five year manufacturer warranty from Omix-Ada
Pilot bushing basics
The pilot bushing holds the front end of the transmission input shaft in the crankshaft, keeping the shaft centered so the clutch disc can engage smoothly. When the bushing wears, the shaft can wobble, which shows up as hard shifting, a whine or difficulty lining up the transmission during installation.
Because the bushing sits behind the clutch, it is usually inspected whenever the clutch is replaced. Clean the bore thoroughly, check for scoring, and fit the bushing squarely with a proper driver. A light coat of grease on the shaft tip helps it slide in without damaging the new bushing.
- Inspect the crankshaft bore for scoring
- Clean the bore before fitting the new bushing
- Check the input shaft tip for wear
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16910.01 |
| UPC | 804314009328 |
| Part type | Pilot bushing |
| Engine application | 4 cylinder |
| Warranty | Limited five year warranty |
Vehicle fitment
It fits Willys MB (1941–1942), Willys trucks, CJ-2, CJ-3, CJ-5 and CJ-6, CJ3, CJ5 and CJ6 (1959–1971), DJ3, DJ5 and DJ6, Dispatcher, Commando, Jeepster, FC150 and FC170, F4, and Utility models.
Wrangler, Cherokee and Gladiator models are not covered by this bushing. Confirm fit for your vehicle’s year, model and trim before ordering.
What’s included
One pilot bushing, Part Number 16910.01.









