Overview
The Omix-Ada 18018.02 is a lower steering shaft boot kit for Jeep CJ5, CJ7 and Scrambler models. It is a direct fit for 1976–1983 CJ5, 1976–1986 CJ7 and 1981–1985 Scrambler vehicles, and the kit is built to original specifications.
The kit is aimed at the lower shaft boot position, and its contents are described in the specifications and included list below.
Key features
- Boot kit with 2 nuts, bearings and springs
- Built to original specifications.
- Covered by a limited five year manufacturer warranty
- Part number 18018.02 with UPC 804314150204
Before starting the job
Lower shaft boot work is mostly about getting the old parts out cleanly and the new ones lined up. Before removing the old boot, mark the orientation of the shaft and the position of any clamp or nut so the reassembly lines up with the steering box. Support the steering column so it does not drop or strain the coupling while the boot is off.
Old boots on CJ models often tear and leave dried grease behind, so clean the shaft and the seating surface before fitting the new boot. Check that the bearings and springs seat evenly and that the boot sits without twisting. A worn coupling or loose steering box can mimic a bad boot, so check the joint for play before closing it up.
- Mark the shaft orientation before removal
- Clean the seating surface before fitting
- Check the joint for play before reassembly
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 18018.02 |
| UPC | 804314150204 |
| Position | Lower |
| Included hardware | 2 nuts, bearings and springs |
| Warranty | Limited five year manufacturer warranty |
Vehicle fitment
It fits 1976–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade), 1976–1986 Jeep CJ7 (Base, Golden Eagle, Golden Hawk, Laredo, Limited, Renegade) and 1981–1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR) models.
Wrangler YJ and later Jeep models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The kit includes its own nuts, bearings and springs, so lay out every piece beside the old boot before starting on the lower shaft.
What’s included
The kit includes a boot with 2 nuts, bearings and springs.














