Overview
The Omix-ADA headlight adjusting screw, part number 12410.01, is a direct OE replacement for Jeep CJ5, CJ6, CJ7 and Scrambler models from 1972 through 1986.
It is built to original specifications for these Jeep models.
Key features
- Direct OE replacement design
- Built to original specifications
- The screw carries a limited five year warranty.
- It fits CJ5, CJ6, CJ7 and Scrambler models.
Before you replace the screw
The headlight adjusting screw sets the aim of the headlamp, so a worn or seized screw can leave the beam pointing high or low. When replacing one, check the threads and the seat in the headlight bucket for damage, and make sure the new screw turns smoothly without binding.
Aim is often checked on a flat wall or with a level surface in front of the vehicle. Adjust both sides evenly, and set the tilt before you tighten the lock. Tire pressure and cargo load can shift the beam, so set aim with the vehicle in its usual condition.
If the screw strips, do not force it. Clean corrosion from the threads with a light penetrating oil and a brush, then recheck fit. Replacing screws in pairs keeps aim consistent on older Jeeps.
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 12410.01 |
| UPC | 804314028794 |
| Part type | Headlight adjusting screw |
| Warranty | Limited five year warranty. |
| Quantity | Sold individually |
Vehicle fitment
The manufacturer fitment list includes the 1972–1983 Jeep CJ5 (Base, Golden Eagle, Laredo, Limited, Renegade), the 1972–1975 Jeep CJ6 (Base), the 1976–1986 Jeep CJ7 and the 1981–1985 Jeep Scrambler.
Wrangler and Cherokee models are not in this list. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Sold individually.












