Overview
The Omix-Ada OAI18670.10 is a front low range gear for Dana 18 and model 20 transfer cases. It has 33 teeth and gear code 18-8-22.
It fits CJ3, CJ5, CJ6 and CJ7 models and Willys CJ-2 through CJ-6 vehicles. Because the gear covers two transfer case types, confirm which one is installed before ordering.
Key features
- Fits Dana 18 and model 20 transfer cases
- 33 teeth
- Gear code 18-8-22 listed
- It is a front position gear.
Spotting a worn low range gear
The low range gear carries the load that moves the vehicle at slow speeds with the transfer case in low range. Because it is used mainly for crawling, its teeth can wear from heavy torque applied under low ratio, and the wear often shows up as a whine under load or a grinding sensation when selecting low range.
A worn gear is usually checked alongside the bearings, synchro parts and shift components that surround it. Inspect the teeth for chipping, pitting or uneven wear pattern. If the gear is replaced, the mating gear and bearings deserve a look as well, because mismatched wear can cause noise and early failure. Keep the lubricant clean and at the proper level, since debris from worn parts shortens the life of the new gear.
- Inspect teeth for chips and pitting
- Check the mating gear for matching wear
- Inspect bearings that support the gear
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | OAI18670.10 |
| Transfer case | Dana 18 and model 20 |
| Teeth | 33 |
| Gear code | 18-8-22 |
| Position | Front |
Vehicle fitment
It fits 1959–1960 and 1966 Jeep CJ3 (Base); 1959–1960 and 1966–1979 CJ5 (Base, Golden Eagle, Renegade); 1959–1960 and 1966–1975 CJ6 (Base); 1976–1979 CJ7 (Base, Golden Eagle, Renegade); and Willys CJ-2 (1946–1949), CJ-3 (1949–1958), CJ-5 (1955–1958) and CJ-6 (1956–1958).
Years and models outside these entries are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Gear work inside a transfer case is usually a professional job, because gear mesh and bearing preload must be set correctly. Ask the installer to check the 33 teeth and 18-8-22 details against your existing gear.
What’s included
The low range gear only.
Not included: shafts, bearings, the case or other gears.










