Overview
The Omix-Ada OAI16585.03 is a small front driveshaft U-joint in the 1210 series for 6 cylinder engines. It fits 1967–1971 Jeep CJ5 and CJ6 models.
It mounts at the front driveshaft at the front axle, and the joint can be greased. It is a direct fit for the CJ5 and CJ6 models above.
Key features
- Small U-joint in the 1210 series
- Lubeable design
- For 6 cylinder engines only
- Positioned at the front driveshaft at the front axle
Driveshaft joint wear
A small U-joint carries torque and changing angles between the transmission output and the front axle. Each joint has bearing caps that rotate on a cross, and that movement wears the bearings over time. Dirt, water and lack of grease speed up that wear, so regular inspection matters more on a vehicle used off road.
When inspecting a joint, check for play by rocking the driveshaft by hand while it is clamped in place. Look for dry, cracked or rusty caps and any sign of grease leaking from the seals. If the joint is being replaced, check the yoke ears for wear and make sure the driveshaft is balanced after reassembly. Installing a new joint on a worn yoke often leads to vibration that comes back quickly.
- Check for play by rocking the driveshaft
- Inspect caps and seals for leaks or cracks
- Check the yoke ears for wear
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | OAI16585.03 |
| U-joint series | 1210 |
| Lubeable | Yes |
| Position | Front driveshaft at front axle |
| Engine | 6 cylinder only |
Vehicle fitment
It fits 1967–1971 Jeep CJ5 (Base) and 1967–1971 Jeep CJ6 (Base).
Other CJ years and models are not in the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The joint is lubeable, so grease it during assembly. Support the driveshaft before removing it to avoid injury.
What’s included
The product is the U-joint.
Not included: the driveshaft, yokes and retaining hardware.









