Overview
The Omix-ADA 16585.02 is a drive shaft U-joint sized at 3-7/32 in. for front or rear drive shaft use. It is a direct OE replacement Jeep part built to the original factory specifications, with a limited five year warranty.
Use this U-joint when a drive shaft joint needs replacing. Measure your existing joint and match it to 3-7/32 in. before ordering.
Key features
- Sized at 3-7/32 in.
- Suits a front or rear drive shaft
- Direct OE replacement design built to original specifications
- Limited five year warranty
Signs a joint is worn
A drive shaft U-joint is a pivot that lets the shaft change angle as the axle moves on the suspension. Under load and over time the bearing caps wear, and the joint starts to feel loose. Because the joint moves constantly, wear usually shows up first as noise or vibration rather than a sudden failure.
When replacing a joint, it is common to inspect the other joints on the same shaft and the slip yoke for wear at the same time. Keeping the drive shaft balanced and the greasing up to date helps the new joint last. Off-road driving with large angles tends to put more stress on joints than steady road use.
- Clunking when shifting from reverse to drive
- Vibration that rises with road speed
- Grease leaking from a cross seal
- Play at the joint when the shaft is turned by hand
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 16585.02 |
| UPC | 804314149758 |
| U-joint size | 3-7/32 in. |
| Position | Front or rear drive shaft |
| Warranty | Limited five year warranty |
Vehicle fitment
It is a Jeep replacement U-joint. Confirm fit for your vehicle’s year, model and trim before ordering.
Compare your existing joint size with 3-7/32 in. before ordering. Confirm your vehicle’s year, model and trim before ordering.
What’s included
This entry is a single U-joint.












