Overview
The Omix-ADA drag link tube, part number 18050.05, is a 34.68-inch tube sold alone. It is designed as an original-equipment replacement to original specifications.
The tube carries a limited five year warranty from Omix-ADA.
Checking tube length on the bench
A drag link tube is only one part of the linkage, so its length must work with the ends and adjusters you already have. Measure your existing link from center to center of each end before ordering, and compare that figure with the tube length. A small difference can change toe setting and steering centering.
Look over the tube and the threads at each end when the link is out. Bends, dents, and cracks near the weld or crimp mean the tube should be replaced. Threads that are damaged or rusted should be cleaned or renewed before reassembly, and jam nuts should be checked for thread damage.
- Measure center to center on the old link
- Inspect the tube for dents and bends
- Clean or replace damaged thread ends
Specifications
| Brand | Omix-ADA |
|---|---|
| Part number | 18050.05 |
| UPC | 804314052973 |
| Tube length | 34.68 inches |
| Included | Tube only |
| Warranty | Limited five year warranty |
Vehicle fitment
Compatibility depends on your vehicle’s year, model and trim, so confirm it before ordering.
Confirm your vehicle’s year, model and trim before ordering. Compare the tube length with your existing drag link.
Installation notes
Because the tube is listed alone, check that your existing ends and adjusters match its fittings before assembly. Measure the installed length against the 34.68-inch tube.
What’s included
Tube only, with the 34.68-inch length. End fittings, adjusters and hardware are not included.
Not included: tie rod ends, adjusters and other drag link components.









