Overview
It is an axle shaft dust cap for a tapered axle. It fits Willys and Jeep models from 1941 to 1960, including the CJ-2, CJ-3, CJ-5, CJ-6 and Willys MB.
A dust cap covers the end of the axle at the hub to keep dirt out. It is a direct OE replacement built to original specifications.
The axle position reads Front, while this cap is associated with a Dana 44 rear axle. Confirm the axle position before ordering by measuring the axle end or comparing the old cap.
Willys and early CJ vehicles used several axle designs, so match the cap to the tapered axle style. Measure the axle end or compare the old cap before ordering, and compare the cap diameter, material and finish against the original before installing.
Key features
- Dust cap for a tapered axle shaft
- Applies to a Dana 44 rear axle setup.
- Direct OE replacement built to original specifications
- Built to the original specifications
- Limited five year warranty from the manufacturer
Choosing the right cap
A dust cap closes the hub end of the axle, keeping water, grit and road debris away from the bearings and the seal area. On an older tapered axle, a cap that is cracked, bent or missing lets moisture into the grease. Inspect it during every bearing service, looking for dents, split seams and corrosion around the rim. Replace it if it no longer seats firmly on the axle end.
When choosing a replacement, the axle style and the axle end matter more than the vehicle name alone. Measure the axle end or compare the old cap side by side before buying. Dust caps are often replaced at the same time as the bearing seal and grease, so check those parts while the hub is open. Clean the mating surface so the cap seats flat.
- Check for dents and split seams
- Look for corrosion at the rim
- Replace the seal if grease is leaking
- Clean the mating surface before fitting
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16712.01 |
| UPC | 804314010188 |
| Part type | Axle shaft dust cap |
| Axle | Dana 44 rear, as noted by Omix-ADA |
| Axle style | Tapered |
| Position field | Front |
| Warranty | Covered by a limited five year warranty. |
Vehicle fitment
It fits these early vehicles:
- 1959–1960 Jeep CJ3 (Base)
- 1959–1960 Jeep CJ5 (Base)
- 1959–1960 Jeep CJ6 (Base)
- 1946–1949 Jeep Willys CJ-2
- 1949–1958 Jeep Willys CJ-3
- 1955–1958 Jeep Willys CJ-5
- 1956–1958 Jeep Willys CJ-6
- 1941–1942 Willys MB (Base)
Only Willys and Jeep models from 1941 through 1960 appear on the list. The Wrangler, Cherokee and later CJ5 and CJ7 years are not covered. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One axle shaft dust cap, part number 16712.01.
Not included: axle shafts, bearings and seals.









