Overview
The Omix-ADA 16712.02 is a zinc-plated axle hub dust cap for front Dana 25 and Dana 27 axles on early Willys and Jeep models.
Omix-ADA asks whether you need to replace your wheel hub bearing dust cap, and offers this zinc-plated one, which protects the wheel bearings by providing a tight seal against the elements.
It fits 41-71 Willys and Jeep models with Dana 25 or Dana 27 axles. Confirm your exact model before ordering, since the three vehicles shown below are specific examples.
Dana 25 and Dana 27 axles were used on early Willys and Jeep vehicles, and this cap seals the hub end on those axles. It is zinc plated, which resists rust on a part at the wheel end. Compare the cap with the original before ordering, and check your model against the vehicles shown below.
Key features
- Zinc plated finish
- For Dana 25 and Dana 27 axles
- Factory style replacement
- Front position
- Seals the wheel bearings against the elements
- Limited 5-year warranty from the manufacturer
Dust cap and hub seal
On early Willys and Jeep front hubs, the dust cap is the outermost barrier between the bearing and road water, mud and grit. A cap that is rusted through, cracked or missing lets contamination reach the bearing grease quickly. Replacing it is a simple job, but it is best done while the hub is already open for service.
Clean the hub face and cap seat before fitting, and tap the cap in evenly so it sits flat. If the hub is being serviced, check the bearing and inner seal too, since a cap alone cannot keep water out of a worn hub. Pack the bearing with fresh grease before reassembly.
- Check the cap for rust, cracks or distortion
- Inspect the hub seal along with the cap
- Use a grease that suits your bearing type
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | 16712.02 |
| UPC | 804314270414 |
| Part type | Axle hub dust cap (wheel hub bearing dust cap) |
| Finish | Zinc plated |
| Axles | Dana 25 and Dana 27 |
| Position | Front |
| Warranty | Limited 5-year warranty |
Vehicle fitment
It fits these vehicles:
- 1953 Jeep Willys CJ-3
- 1950 Jeep Willys Jeepster
- 1951 Jeep Willys Sedan Delivery
The list names a 1953 Willys CJ-3, a 1950 Willys Jeepster and a 1951 Willys Sedan Delivery. Wrangler, Cherokee and later CJ models are outside it. Confirm your vehicle’s year, model and trim before ordering.
What’s included
One dust cap, part number 16712.02.
Not included: bearings, seals and other hub hardware.












