Overview
The Mountain Off Road Enterprises XML12 is a left hand thread rod end with a 3/4 inch bore and a 3/4-16 threaded shank. It is meant for builders making their own tie rods, track bars, radius arms or link bars, and it comes with a jam nut.
The hole through the ball matches the diameter of the threaded shank. The rod end is built with a 52100 bearing steel ball, a Teflon/Kevlar self-lubricating race and an alloy steel heat-treated body, which gives it a race-car quality build.
Key features
- Left hand thread for opposite-side links
- 52100 bearing steel ball
- Teflon/Kevlar self-lubricating race
- Alloy steel heat-treated body
Building a custom link
Custom links are only as good as the parts that connect them. A rod end sits at each end of a tie rod or track bar, so its thread, bore and body all have to work with the tube it is threaded into. Before building, confirm the shank will engage the tube or sleeve fully, and decide whether the link needs to be adjustable for alignment.
Thread engagement and jam nut tightening are the points that most often fail on a home build. Set the rod end to the correct length first, then tighten the jam nut against the tube so the setting holds under vibration. After the first drive, look for cracks around the body, wear in the race and any change in the length setting.
- Test fit the rod end before final assembly
- Set link length before tightening the jam nut
- Look for cracks around the body
- Recheck the setting after the first drive
Specifications
| Brand | Mountain Off Road Enterprises |
|---|---|
| Part number | MREXML12 |
| Shank | 3/4 inch – 16 thread |
| Bore | 3/4 inch |
| Thread direction | Left hand |
| Ball | 52100 bearing steel |
| Race | Teflon/Kevlar self-lubricating |
| Body | Alloy steel, heat-treated |
| Fitment | Universal fit |
Vehicle fitment
This rod end is universal fit, so it is not built for one vehicle. It is sized for building custom linkage, and the thread and bore should be checked against your own tube or link before assembly.
Installation notes
Thread the rod end into the tube or sleeve and tighten the jam nut against it. Confirm thread engagement before the link carries load.
What’s included
A jam nut is included with the rod end.
Not included: The tube, sleeve or other linkage parts needed to build a finished link.








