Overview
The Mountain Off Road Enterprises 9927Z is a heavy-duty drag link for the Jeep CJ5, CJ7 and Scrambler from 1982 to 1986. It is made from 1 inch O.D. by .219 wall D.O.M steel tubing with threaded 5/8 rod ends.
The rod ends are race-car quality, Teflon and Kevlar lined and self lubricating. The alloy steel rod end bodies are heat treated and plated, and the link mounts under or over the knuckles. It is designed for Dana 30 wide track axles.
Key features
- 1 inch O.D. by .219 wall D.O.M steel tubing
- Threaded 5/8 left and right rod ends with wrench flats
- Teflon and Kevlar lined, self lubricating rod ends
- Heat treated, plated alloy steel rod end bodies
- Mounts under or over the knuckles
Drilling and fitting the rod ends
A drag link carries the steering force from the steering box to the knuckles, so its ends must be secure and free of play. On a CJ with the stock tapered hole, the rod end has to be fitted into a straight hole before the link will seat properly, which is why the hole preparation matters.
Check the knuckle and steering arm for cracks before fitting, and clean the threads so the jam nuts run freely. Rod ends that show binding or roughness should be replaced rather than forced. Inspect the link after the first few drives for play at each end, since drilling and fitting can shift alignment.
Steering alignment should be checked after the drag link is installed, especially if the vehicle has changed tire size or suspension height. Inspect the rod ends for play at routine service intervals.
- Clean threads before fitting
- Check knuckles and steering arms for cracks
- Recheck alignment after installation
- Inspect rod ends for play at service
Specifications
| Brand | Mountain Off Road Enterprises |
|---|---|
| Part number | 9927Z |
| UPC | 70000503484 |
| Tubing | 1 inch O.D. x .219 wall D.O.M steel |
| Rod end thread | 5/8 left and right |
| Rod end body | Alloy steel, heat treated and plated |
| Finish | Zinc plated |
| Axle compatibility | Dana 30 wide track |
Vehicle fitment
It fits the 1982–1983 Jeep CJ5 (Base, Laredo, Limited, Renegade), the 1982–1986 Jeep CJ7 (Base, Laredo, Limited, Renegade) and the 1982–1985 Jeep Scrambler (Base, Laredo, Renegade, SL, SR).
Years before 1982 and Jeep Wrangler models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The stock tapered hole must be drilled out to a straight 5/8 inch hole before the rod ends fit. Jam nuts and grade 8 hardware are provided. Wear eye protection when drilling.
What’s included
Jam nuts and grade 8 hardware are included. The rod ends are part of the link.









