Overview
The Motive Gear C9.25-355 is a ring and pinion gear set with a 3.55 gear ratio for Chrysler 9.25 inch rear axles, sold under part number MIDC9.25-355. It is a light duty O.E. quality replacement for on-road and off-road driving.
A ring and pinion sets the final drive ratio of a differential, so the 3.55 figure is the number to match against your current gearing. Motive Gear says gears of this type are found in everyday automobiles, trucks and vans.
Key features
- Light duty O.E. quality replacement gear set
- 8620 steel gears
- CNC machined throughout
- Computer controlled heat treatment
- 3.55 gear ratio
Choosing the ratio
The ratio is the number of driveshaft turns needed for one wheel turn, and it sets how the axle trades acceleration against cruising speed. A numerically higher ratio gives stronger pulling from a stop, while a lower one tends to suit steady highway use. Before buying, compare the ratio you have now with 3.55 and think about how the tire size you run changes the effective gearing.
Ring and pinion gears are usually replaced together with the bearings and carrier shims that set their position. If the carrier bearings are worn or the housing has been bent, a new set may not run quietly. Check the housing for damage and make sure the axle bearings are in good condition before the gears go in.
- Compare the current ratio with the new set before ordering
- Tire diameter changes the effective gearing
- Check the housing for cracks or distortion
- Use fresh axle fluid once the set is broken in
Specifications
| Brand | Motive Gear |
|---|---|
| Part number | MIDC9.25-355 |
| Axle manufacturer | Chrysler |
| Axle location | Rear |
| Axle type | Chrysler 9.25 inches |
| Gear ratio | 3.55 |
| Gear material | 8620 steel |
| Machining | CNC throughout |
| Heat treatment | Computer controlled |
Vehicle fitment
It is made for the Chrysler 9.25 inch rear axle type at a 3.55 ratio.
Confirm your vehicle’s year, model and trim before ordering. Measure your axle housing and confirm the axle type and 3.55 ratio before choosing this gear.
Installation notes
Gear sets like this need professional setup, with pinion depth, bearing preload and backlash set during installation. Plan for a break-in period as directed by the installer.
What’s included
The title identifies one ring and pinion gear set, 3.55 ratio, for the Chrysler 9.25 inch rear axle.
Not included: Pinion bearings, shims and installation hardware may be needed in addition to the gear set. Check the package contents against your installation before starting.









