Overview
The Method Race Wheels 701 Trail Series 17×8.5 in Matte Black, part number MRWMR70178562500, is a 17-inch aluminum off-road wheel with an 8.5-inch width. It has a 6 on 120 bolt pattern, a center bore of 67, an offset of 0 and a backspacing of 4.75, and those hub measurements decide whether it mounts on a given vehicle.
Method casts each wheel in one piece from 356 aluminum, then heat treats it to T6 condition. The patent pending Bead Grip feature works with the tire bead seat so the tire holds firmly at reduced pressure. The reinforced inner lip comes from race wheel design, and raised safety humps on both bead seats stabilize the tire and guard against de-beading. The design aims for lower weight with higher strength, shaped by finite element analysis and field tests.
Key features
- One-piece cast 356 aluminum construction
- T6 heat treatment
- Patent pending Bead Grip technology
- Reinforced inner lip from race wheel design
- Safety humps on the inner and outer bead seat
- Windowed style in Matte Black
- Method reports lighter weight with higher strength
Wheel weight and unsprung mass
Wheel weight counts for more than most drivers expect, because the wheel and tire move up and down with the suspension. Lighter wheels reduce unsprung mass, which can help the suspension follow ground contours and give the tire more consistent contact on rough terrain. The lighter build aims at that benefit, though the overall gain depends on the tire and the rest of the wheel package.
When comparing wheels, check the bolt pattern, center bore and offset first, then think about weight and finish. Matte black hides scuffs well but shows mud and tire dressing more readily than bare aluminum, so plan on cleaning it after trail runs. Keep the tire and wheel weight in mind when adding a spare, since a heavier tire can offset what the wheel saves.
- Compare bolt pattern and center bore first
- Weigh tire and wheel together
- Clean matte finish after trail runs
Specifications
| Brand | Method Race Wheels |
|---|---|
| Part number | MRWMR70178562500 |
| Series | 701 Trail Series, MR701 Bead Grip |
| Wheel diameter | 17 Inches |
| Wheel width | 8.5 Inches |
| Bolt pattern | 6 on 120 |
| Center bore | 67 |
| Offset | 0 |
| Backspacing | 4.75 |
| Style | Windowed |
| Construction | Aluminum, one-piece cast 356, T6 heat treatment |
| Finish | Matte Black |
Vehicle fitment
No year, make, model or trim is tied to this wheel. Use the hub’s bolt pattern, center bore and offset as the test: 6 on 120, 67 and 0. Confirm your vehicle’s year, model and trim before ordering.
A hub drilled for a different pattern will not accept a 6 on 120 wheel, and that mismatch cannot be fixed with lug nuts alone.
Installation notes
Measure the hub before mounting. If the hub’s centering diameter is larger than the 67 bore, a hub-centric ring is typically used so the wheel centers on the hub rather than the lug studs. Tighten lug nuts in a star pattern to the torque your vehicle requires, and recheck them after the first drive.
What’s included
The wheel itself, one 17×8.5 unit in Matte Black.
Not included: Tires, center caps and lug hardware are not part of this package.















