Overview
The G2 Axle and Gear 85-2015M-28 is a 28 spline mini spool for GM 10 bolt 7.5 inch rear axles. G2 Axle and Gear presents it as an economical traction device, machined from 4130 billet steel, with fewer set-up difficulties than other traction options.
Confirm that your axle shafts carry 28 splines before choosing this unit, because the number has to match for the spool to engage correctly.
Key features
- 28 spline mini spool for the GM 10 bolt 7.5 inch rear
- Machined from 4130 billet steel
- A low-cost option for locking the rear axle shafts together.
- Spool-type differential that locks the axle shafts together
Checking spline count first
A mini spool sits where an open differential would, and it locks the two shafts so both wheels turn at one speed. That keeps power flowing when one wheel lifts or slips on loose ground. The same lock makes steering harder on hard pavement, so many drivers reserve a spool for off-road work.
Before fitting, inspect the carrier bearings, the ring gear and the pinion. A worn ring gear pattern or a bearing that feels rough during turning should be replaced while the carrier is out. Keep the gear oil at the level the housing needs and change it after a rebuild, since fresh lubricant protects the new gears. Mark the carrier and caps so they go back in the same positions.
- Carrier bearings and seals
- Ring gear and pinion condition
- Fresh gear oil at the right level
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 85-2015M-28 |
| UPC | 631410103557 |
| Axle type | GM 10 Bolt 7.5 inches |
| Popular axle manufacturer | GM |
| Axle location | Rear |
| Axle spline | 28 splines |
| Differential type | Spool |
| Material | 4130 billet steel |
Vehicle fitment
This spool is universal fit for GM 10 bolt 7.5 inch axles. No years or chassis codes come with it, so the housing measurement and spline count are the deciding checks.
Models that use a different axle housing than the GM 10 bolt 7.5 inch type are not covered by this mini spool. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Fitting the spool calls for removing the carrier from the housing, then setting ring gear backlash and bearing preload. Keep the vehicle supported on stands, and have a shop with gear setup experience handle the rebuild.
What’s included
The 28 spline mini spool itself.
Not included: the rest of the carrier assembly is needed from another source.







