Overview
The G2 Axle and Gear 65-2022 is an open differential carrier for GM 10 bolt rear axles in the 8.6 inch size, sold as an empty case that takes a ring and pinion set. It is described by the brand as a direct replacement for the factory differential, with the case break set for the gear ratio you choose.
Carriers like this one suit rear ends that need a new case while gear selection stays open. GM is the usual axle maker for the GM 10 bolt 8.6 inch type, so measure your housing against that size first.
Key features
- Case replaces the factory open differential in an 8.6 inch GM 10 bolt
- Bare case, leaving gear selection to the builder
- Case break chosen for the ratio, per the manufacturer
- Suited to repairs where a complete carrier is more than needed
Preparing a bare case
A bare differential case is only the housing for the gear set, so the work begins after it arrives. Choose the ring and pinion ratio first, because the case break and gear mesh have to suit that choice. Matched gears from one set are the usual route, and the new set should be cut for the same ratio as the case.
Bearings, shafts and pinion depth all affect how the finished unit runs, so inspect the housing bores and bearing seats before assembly. Look for scoring, cracks or worn seats, since any of those can shift the carrier out of position. Keep parts sorted by side and work on a clean bench. Tools for measuring backlash and pinion depth are worth having on hand before the job starts, and a shop with that equipment can save a second teardown.
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 65-2022 |
| UPC | 631410096392 |
| Axle type | GM 10 Bolt 8.6 inches |
| Popular axle manufacturer | GM |
| Axle location | Rear |
| Differential type | Open differential case only |
| Axle spline | Empty case |
Vehicle fitment
This carrier is universal fit, with no vehicle years or chassis codes attached. Use the 8.6 inch housing size and your pinion setup to decide whether it matches your axle.
Axles outside the GM 10 bolt 8.6 inch type named here are not covered by this carrier. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Installing a bare case means removing the carrier from the housing, fitting a matched ring gear and pinion, and setting backlash and bearing preload to specification. Plan on a shop with gear setup experience. Keep the vehicle securely supported on stands while the axle is open.
What’s included
The empty differential case only.
Not included: the gear set, bearings and axle shafts need to come from another source.






