Overview
The G2 Axle and Gear 85-2034-3-30 is a 30 spline full spool for Dana 60 rear axles, with 4.10 Down gearing. Installed in place of the open differential, it locks both axle shafts together so the wheels share power even when one lifts. It is CNC machined from 4130 billet steel and has a light weight build.
Key features
- Billet 4130 steel, CNC machined into a light weight spool
- Full spool sends power to both wheels when one is in the air
- Built for 30 spline axle shafts
- Rear Dana 60 axle type
- Suited to 4.10 Down gearing
Matching spline count and ratio
A spool replaces the open differential, so the axle shafts share torque in a fixed way instead of splitting it. That gives traction when one wheel is light, but it also loads the gear teeth and bearings more than an open setup does. Gear tooth contact should be checked after fitting, and a rough pattern is a sign the setup needs attention.
Match the spool to the ratio you run and to the shaft count before ordering. Bearings and seals are worth inspecting during the install, since the carrier is open and load patterns change after a spool goes in. Keep gear oil at the level the housing needs and change it after the first break-in drive.
- Ring and pinion ratio
- Axle shaft spline count
- Carrier bearings and seals
Specifications
| Brand | G2 Axle and Gear |
|---|---|
| Part number | 85-2034-3-30 |
| UPC | 631410103434 |
| Differential type | Spool |
| Material | 4130 billet steel, CNC machined |
| Axle type | Dana 60 |
| Axle location | Rear |
| Axle spline | 30 splines |
| Gear ratio | 4.10 Down |
| Popular axle manufacturer | Dana |
| Fitment listed | Universal fit |
Vehicle fitment
It is universal fit for rear Dana 60 axles with 30 spline shafts. The spline count on your axles is the key check.
The 35 spline version is part number 85-2034-3, and this 30 spline spool is meant for 30 spline shafts only. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
Spool installation replaces the open differential and changes how the axle shafts share torque, so a gear pattern check after fitting is normal practice. Match the 30 spline count and 4.10 Down ratio to your existing axle components before starting.
What’s included
Only the spool itself is included.
Not included: bearings, ring gear and pinion hardware must be sourced separately.







