Overview
The Factor 55 ProLink XTV, part number 00110-02, is a winch shackle mount for UTV and ATV winches. It replaces the conventional winch hook with a screw pin shackle or D-ring, giving the recovery line a closed attachment point instead of a hook.
Factor 55 explains the reason for the change. Winch hooks can cut and fray recovery straps, and strap ends can escape a hook during the loose and tight cycles of a winching recovery. A screw pin shackle does not allow strap loops to escape because its pin screws into place. The XTV carries that approach to the winch line and is made in the USA from 6000 series billet aluminum and 6Al-4V titanium.
Key features
- Replaces the winch hook with a screw pin shackle or D-ring connection
- No splicing needed; works with steel cables or synthetic ropes up to 5/16 inch
- Cable eye held by a 7/16 inch titanium double shear pin and internal snap ring
- EPDM rubber guard with four barbed tips protects alloy fairleads
- Stows neatly against roller or hawse type fairleads
- Installs in minutes and is anodized and powder coated in five colors
Choosing the right winch line
A winch line is only as good as the connection at its end, so the shackle mount deserves the same attention as the cable or rope. Synthetic rope and steel cable behave differently under load. Synthetic rope stretches and stores energy, while steel cable holds a fixed shape and can kink when pulled at an angle. Before choosing a line, consider how often you recover, how far you typically pull, and whether your winch drum spools evenly. Matching line diameter to the mount and the fairlead keeps the setup running smoothly.
Inspect the shackle mount after each recovery. Look for flattening or bending on the body, wear on the shackle hole, and any scoring where the line passes over the fairlead. Check the titanium pin and snap ring for damage, and replace either one if it looks worn or does not seat fully. Rope that shows fuzzing, cuts, or glazed sections should be retired. A worn line is a common reason a recovery fails, so treat inspection as part of every trip.
Specifications
| Brand | Factor 55 |
|---|---|
| Part number | 00110-02 |
| UPC | 700006932171 |
| Cable or rope capacity | Steel cable or synthetic rope up to 5/16 inch |
| Retaining pin | 7/16 inch diameter titanium double shear pin with internal snap ring |
| Shackle size | Designed for common standard 1/2 to 5/8 inch shackles |
| Body material | 6000 series billet aluminum and 6Al-4V titanium |
| Guard | EPDM rubber, four barbed tips |
| Finish | Anodized and powder coated, five colors |
| Max load rating | 6000 pounds |
| Ultimate failure | 22,000 pounds |
| Made in | USA |
| Fitment | Universal fit |
Vehicle fitment
It is a universal fit winch accessory for UTV and ATV winch lines, not a part sized for one vehicle. Match the cable or rope diameter and the shackle size to your setup.
Confirm the winch cable or rope is no thicker than 5/16 inch and that your shackles fall in the 1/2 to 5/8 inch range.
Installation notes
The XTV goes on in place of the winch hook, and no splicing is required. The cable eye sits inside the body and is held by the titanium pin and snap ring, so check that the snap ring is fully seated before the line takes load. Fairlead type matters, since the guard fits hawse and roller designs.
What’s included
One ProLink XTV shackle mount, part number 00110-02.
Not included: Screw pin shackles or D-rings, which the XTV is designed to use.


























