Overview
The Fabtech FTS742 is an axle U-bolt kit meant to clamp an axle to its springs. It is sold as one kit and is marked universal fit, with no particular make, model or year identified.
Fabtech part number FTS742 and UPC 674866015555 are the identifiers to match when comparing this kit with others.
Key features
- Four U-bolts
- Eight Nylock tall nuts
- Eight thick flat washers
- Sold as a kit
Before fitting a universal kit
A universal U-bolt kit is only as good as the match between its U-bolts and the axle and spring pack it clamps. Measure the axle tube diameter and the spring seat width before assembly, and make sure the U-bolts reach around the axle without pinching the spring. Clamp force comes from the nuts, so both sides should be tightened evenly to avoid twisting the axle.
Good preparation helps the clamp hold. Clean the threads and mating surfaces, and check that the washers sit flat against the plate. Look over the U-bolts for bent ends or nicks that could weaken the bend. Damaged parts should be replaced before the axle goes back under load.
- Measure the axle tube diameter
- Check the spring seat width
- Tighten the nuts in an even pattern
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FTS742 |
| UPC | 674866015555 |
| Included hardware | Eight Nylock tall nuts, four U-bolts and eight thick flat washers |
Vehicle fitment
Fitment is not tied to a named vehicle for this kit. Because Fabtech lists universal fit only, confirm axle width, spring type and mounting points on your own truck before using the parts.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
Eight Nylock tall nuts, four U-bolts and eight thick flat washers make up the set.







