Overview
The Fabtech FTS810612 is a Dirt Logic 2.25 rear shock absorber for the 2007-2013 Toyota Tundra, built for a 2 in. lift. It is a gas charged monotube design with a stainless steel finish and no reservoir.
The Dirt Logic 2.25 monotube gas charged design is built for large diameter damping on lifted vehicles. It mounts in the OE mounting position as well as in multiple shock configurations.
Confirm the shock length against your suspension height before ordering.
Key features
- Dirt Logic 2.25 monotube shock
- Gas charged
- Stainless steel
- Non-reservoir design
- Rear position
- Built for a 2 in. lift
- Mounts in the OE position
Checking shock length
Shock length matters because it sets the range the suspension can travel. A shock that is too short can bottom out, while one that is too long can bind at full extension. When the ride height changes, the shock’s extended and collapsed lengths need to suit the new travel so the tire and brake hose clearance stays safe.
Rear shocks often wear at the bushings and rod seal before the body fails. Watch for oil on the shock body, worn eye bushings, and a ride that feels bouncy or sags at the back. After installation, cycle the suspension by hand to check for binding, and re-check the mounting hardware after the first drives. Recording the new ride height helps when comparing the shock later.
- Eye bushings and mounting hardware
- Oil on shock body
- Brake hose and tire clearance at full travel
Specifications
| Brand | Fabtech |
|---|---|
| Part number | FTS810612 |
| UPC | 674866095120 |
| Product type | Shock absorber |
| Series | Dirt Logic 2.25 |
| Position | Rear |
| Design | Monotube, non-reservoir |
| Material | Stainless steel |
| Hydraulic / gas charged | Gas charged |
| Lift height | w/2 in. lift |
| Fit type | Direct fit |
Vehicle fitment
The stored manufacturer fitment list for the Fabtech FTS810612 covers the 2007-2013 Toyota Tundra in Base, Limited, Platinum and SR5 trims.
This rear shock fits the 2007-2013 Tundra only, with a 2 in. lift. Other Tundra generations are not covered. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Shocks control wheel movement and vehicle stability, so professional installation is recommended. Re-check the hardware after the first miles of driving, and have the alignment and ride height checked after any suspension work.
Re-check the hardware after the first miles of driving. Replace shocks in axle pairs where the manufacturer advises it, and have the alignment and ride height checked after any suspension work.
Compare the package part number with FTS810612 before fitting and make sure all parts are there. Use level ground and eye protection while working, and keep any instruction sheet nearby.
Replace shocks in axle pairs where the manufacturer advises it, and check that the shock does not bind at full suspension travel.
What’s included
One rear shock. Mounting hardware and the matching front shock are not included.








