Overview
The Fabtech K20321DL is a 6-inch 4-link lift with Dirt Logic SS 4.0 coilovers and rear Dirt Logic SS shocks for the 2008–2010 Ford F-350 Super Duty. The arms replace the factory arms directly. Their 1-inch ID stainless American Uniball fits into the factory ball joint taper, which eliminates the upper ball joint.
The 4340 heat-treated Uniball pin needs no spindle modification, so a return to stock is straightforward. The chromoly tubing reduces flex compared with the stock arms, and built-in additional caster helps alignment when a leveling kit is in use. The kit pairs the arms with Dirt Logic 2.5 coilover shocks for increased wheel travel. It is limited to factory aluminum suspension vehicles.
Key features
- 6-inch lift, range 5 to 6.99 inches
- Dirt Logic SS 4.0 coilovers
- Rear Dirt Logic SS shocks
- 1-inch ID stainless American Uniball
- 4340 heat-treated Uniball pin
- Built-in additional caster in the arms
Uniball arms and alignment
Uniball arms carry the load at the upper end of the front suspension, so the pin and its housing take steering and braking forces that a ball joint would normally handle. Inspect the Uniball for play or binding during routine service, and check that the pin is still seated firmly in the taper. Dust boots and grease fittings deserve attention, because dirt that works into the joint will shorten its life.
Caster and alignment changes often come with a 4-link setup, so schedule an alignment after installation and again after any suspension adjustment. Coilover shocks increase wheel travel, which can also change how the tires sit under the fenders. Keep an eye on driveline angles and brake hose length during the first few drives.
- Grease the Uniball joint on schedule
- Inspect dust boots for tears
- Check alignment after the first drive
- Watch brake lines at full droop
Specifications
| Brand | Fabtech |
|---|---|
| Part number | K20321DL |
| UPC | 674866096288 |
| Lift height | 6 inches (range 5 to 6.99 inches) |
| Suspension type | Coilover, 4-link |
| Upper ball joint | Eliminated by the arm design |
| Rear lift method | Lift blocks and U-bolts |
| Shocks | Dirt Logic SS shocks included |
| Tire and wheel fit | 295/70R17 on 17×8, 275/65R18 on 18×8, 285/55R20 on 20×9; 4 1/2-inch and 5-inch backspacing |
Vehicle fitment
The K20321DL fits the 2008–2010 Ford F-350 Super Duty, including Cabela’s, FX4, Harley-Davidson, King Ranch, Lariat, XL and XLT models.
It fits only vehicles with factory aluminum suspension. It does not fit Factory AutoRide shocks, all-wheel drive models or standard cab trucks, and the F-250 Super Duty is not covered. Match your vehicle’s year, model and trim to this fit before ordering.
Installation notes
Check the factory suspension for the aluminum or steel version before installing, since the arms are made only for the aluminum type. The OEM wheel and tire cannot be used with this system, so the tire and wheel must be changed to the sizes listed.
What’s included
The 4-link arms with Uniball pins, Dirt Logic SS 4.0 coilovers at the front, the rear block and U-bolt kit and Dirt Logic SS shocks at the rear.









