Overview
The Fabtech 2.5 Inch Coil Spacer Lift Kit, part number K3056, is a 2.5 inch front coil spacer lift system for the 2013-2016 Ram 3500 with radius arm front suspension. It covers the Big Horn, Laramie, Laramie Limited, Laramie Longhorn, Lone Star, SLT, ST and Tradesman trims.
The angled spacers keep the large bow that Dodge built into the front coil springs, which preserves the factory ride characteristics. The front shocks are replaced with longer units for full suspension travel, and extended length bump stops prevent coil spring binding at full compression and clear the track bar.
Fabtech lists tire and wheel combinations that fit with minor trimming: 315/70R17 tires with 17×9 wheels, 325/65R18 tires with 18×9 wheels, and 325/60R20 tires with 20×9.5 wheels.
Key features
- 2.5 inch front lift using coil spacers
- Angled spacers preserve the factory coil spring bow
- Longer length front shocks
- Extended length bump stops included
- Eliminates track bar interference
- Front position
- Direct fit for the Ram 3500
Setting up after a lift
A coil spacer lift changes the ride height without changing the springs’ rate, so the truck will still feel different on the road. Heavier loads and long highway runs show the change most, and steering response may feel lighter until the alignment is set. Plan the install around a day when you can complete the work and road-test the truck afterwards.
Check the driveline angles and brake hoses once the lift is complete, since changed geometry can stretch hoses and push the driveshaft too far. Re-tighten suspension hardware after the first drive, and look at the bump stops and shocks after rough roads. Replace worn tie rod ends, ball joints or track bar bushings while the front end is apart, because they are often replaced in the same job.
Specifications
| Brand | Fabtech |
|---|---|
| Part number | K3056 |
| Product type | Coil spacer lift kit |
| Lift height | 2.5 Inches |
| Type | Front |
| Included | Angled coil spacers, longer front shocks, extended length bump stops |
| Tire and wheel fit | 315/70R17 with 17×9 wheels; 325/65R18 with 18×9 wheels; 325/60R20 with 20×9.5 wheels, with minor trimming |
| Fit type | Direct fit |
Vehicle fitment
It fits the 2013-2016 Ram 3500 in Big Horn, Laramie, Laramie Limited, Laramie Longhorn, Lone Star, SLT, ST and Tradesman trims, with radius arm front suspension.
Fit is for the 2013-2016 Ram 3500 only. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Coil spacers raise the body and shift how the suspension works, so a professional install helps keep steering predictable. Use rated stands on level ground.
- Follow the torque values in the instructions and revisit the hardware after a short drive.
- Have the alignment checked once the spacers are installed.
- Confirm clearance for brake lines, steering and the driveshaft, as well as for the tires at the fenders.
- Check local rules on vehicle height.
What’s included
- Angled coil spacers
- Longer front shocks
- Extended length bump stops






