Overview
The Fab Fours DR13-F2952-1 is a sensor winch front bumper with a pre-runner guard for 2013 to 2018 Ram 1500 trucks, finished in black powder coat and made for winches up to 12,000 lb.
The bumper is built for strength and durability and gives more tire clearance. It uses a two-piece mounting system that can be adjusted for a custom fit, and it includes injection molded light housings with 90mm fog lights and 60mm turn indicator lights.
Key features
- Winch ready: accepts winches up to 12,000 lb or smaller
- Black powder coat finish
- Far more tire clearance
- 1-inch D-ring mounts
- Two-piece mounting system with adjustability for a custom fit
- Injection molded light housings
- 90mm fog lights and 60mm turn indicator lights included
Before adding a winch
A winch bumper carries more load than a standard front bumper, so the mounting points and the frame behind them matter. Before fitting a winch, check that the brackets sit square, that the bolts are tight and that the truck’s frame is in good condition. Recovery pulls and rough trail work can loosen fasteners over time, so inspect the mounts after the first few outings and again at regular service intervals.
Plan the electrical side early. Fog and turn lights need a clean, protected run to the truck’s wiring, and a winch draws a large current, so a properly sized fused feed is important. Route cables away from hot exhaust parts and moving suspension components, and keep the battery terminals clean. Recovery straps and shackles should be rated for the load and checked often for cuts, fraying and wear.
- Confirm the winch’s rated pull is within the bumper’s limit
- Use a fused feed sized for the winch
- Inspect cables and connectors after heavy use
Specifications
| Brand | Fab Fours |
|---|---|
| Part number | DR13-F2952-1 |
| UPC | 5810109127 |
| Type | Sensor winch front bumper, pre-runner guard |
| Position | Front |
| Width | Full |
| Material | Steel |
| Finish | Black powder coat |
| Fit type | Direct fit |
| Winch mount | Included (up to 12,000 lb winches) |
| Lights | 90mm fog and 60mm turn indicator lights included |
| D-ring mounts | 1-inch |
Vehicle fitment
It fits the 2013 to 2018 Ram 1500.
Ram 2500 and 3500 trucks, and Ram 1500 years before 2013, are not on the list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The two-piece mounting system is adjustable, so the fit can be tuned on the truck. If a winch is added, use one that is 12,000 lb or smaller and wire it with a fused feed. Fog and turn lights in the supplied housings need to be connected to the truck’s wiring, so allow time for that.
What’s included
- Sensor winch front bumper with pre-runner guard
- Winch mount
- 90mm fog lights
- 60mm turn indicator lights
Not included: The winch and its wiring.









