Overview
The Fab Fours FF09-D1951-1 is a Vengeance Series front bumper for 2009 to 2014 Ford F-150 trucks, a lightweight non-winch steel sensor bumper in a two-stage black powder coat.
The Vengeance bumper leaves room for a 20-inch LED light bar in the center and carries mounting options on each side for two 2×2 Dually lights, which Fab Fours says gives maximum LED light coverage. A lower cutout allows air to reach the intercooler, and the bumper bolts on with brackets that tie directly to the frame.
The Vengeance Series comes with a no guard or a pre-runner guard option. The steel bumpers are built for light weight with a clean finish. The high and tight fit and the cutouts give an aggressive look on and off the road. Brackets provided with the bumper tie directly to the frame, making it a complete bolt-on front bumper.
Key features
- Lightweight: Fab Fours lists 65 lb with no guard and 75 lb with the pre-runner guard
- Integrated 20-inch LED light bar position in the center (bar not included)
- Side mounting options for two 2×2 Dually lights
- Lower cutout to provide airflow to intercoolers
- Complete bolt-on bumper with brackets that tie directly to the frame
- Two-stage black powder coat
- 12 ga. U.S. steel construction
- Made in the USA
Front bumper lighting and sensors
Lighting on a front bumper sits in the most exposed spot on the truck. Light bars and Dually lights take impacts from brush and gravel, so the mounts and wiring need regular attention. Position lights so they clear the grille and hood edge, and keep the beam aimed low enough to avoid blinding oncoming traffic.
Parking sensors can behave differently with a front bumper that has a sharp lower edge or a different face angle. Test the sensors at low speed after installation, and watch for false alerts on curbs or tall grass. Clean the sensor faces after muddy drives and check that wiring stays clear of the lower cutout and moving parts.
- Route light harnesses away from heat
- Test sensors at low speed after fitting
- Clean sensor faces after muddy trips
- Keep lower cutout clear of wiring
Specifications
| Brand | Fab Fours |
|---|---|
| Part number | FF09-D1951-1 |
| UPC | 5810110772 |
| Type | Vengeance front bumper, non-winch |
| Position | Front |
| Width | Full |
| Material | Steel, 12 ga. U.S. steel |
| Finish | Two-stage black powder coat |
| Fit type | Direct fit |
| Light mounts | Included |
| Winch mount | Not included |
Vehicle fitment
Fab Fours lists FF09-D1951-1 for the 2009 to 2014 Ford F-150.
The 2015 and newer F-150 generation is not covered by this part number. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The brackets that come with the bumper attach straight to the frame. Add lights only through a fused relay, and keep the lower cutout open so intercooler air can pass through it.
What’s included
- Vengeance front bumper in black powder coat
- Frame brackets for bolt-on installation
Not included: The LED light bar and the Dually lights.


















