Overview
The DrawTite 75236 is a Class III/IV rear max-frame trailer hitch for the 2005–2013 Toyota Tacoma in Base and Pre Runner trims. Its 2 inch by 2 inch receiver is rated at 5000 lb gross trailer weight and 500 lb tongue weight, or 5500 lb and 550 lb with weight distribution.
The hitch is all-welded and built without adapters, and it needs no drilling. It suits Tacoma owners who need a rear receiver for towing.
Key features
- Class III/IV rating with 5000 lb gross trailer weight and 500 lb tongue weight
- With weight distribution, rated for 5500 lb trailer weight and 550 lb tongue weight
- 2 inch by 2 inch receiver opening
- All-welded construction, built without adapters
- No drilling required, with a listed install time of 30 minutes
- DrawTite backs its hitches with a nationwide lifetime warranty
Towing with a rear receiver
A rear receiver carries the trailer through the frame, so the rated gross trailer weight and tongue weight both matter. Tongue weight is the downward load the trailer places on the ball, and it is only part of the total. Keep the loaded trailer within both figures and check that the load is spread evenly.
A weight distribution system can raise the usable rating, but it works only when the ball mount, spring bars and trailer are set up to match. Check that the ball and mount are sized for the receiver and the load before each trip. Inspect the welds and bolts after rough towing.
- Check the hitch pin and clip before every trip
- Confirm trailer brakes and lights work before leaving
Specifications
| Brand | DrawTite |
|---|---|
| Part number | 75236 |
| UPC | 742512752366 |
| Hitch class | Class III/IV |
| Receiver size | 2 inch x 2 inch |
| Position | Rear |
| Gross trailer weight (GTW) | 5000 lb |
| Tongue weight | 500 lb |
| Weight distributing trailer weight | 5500 lb |
| Weight distributing tongue weight | 550 lb |
| Roll pan compatibility | Does not fit with roll pan |
| Install time | 30 min |
| Drilling | No drilling required |
Vehicle fitment
The hitch fits the 2005–2013 Toyota Tacoma in Base and Pre Runner trims as a direct-fit rear installation.
Tacoma model years outside 2005–2013 are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
DrawTite gives an install time of 30 minutes and no drilling. Support the vehicle safely while you fit the hitch.
What’s included
Confirm the included fasteners against the installation steps before starting.














