Overview
The Timken differential bearing is a single specialty bearing for 30 spline Dana 30 E locker differentials, and it is also named for Dana 35 aftermarket lockers. GM 10 bolt 98 and older units with aftermarket 30 spline lockers are another named use.
Timken describes its bearings as top quality steel, precision heat treated and ground to industry standards. The part carries a Direct Fit label, but no vehicle years are stated.
Key features
- Single bearing, not a set
- Built for 30 spline lockers
- Precision heat treated and ground steel.
- Direct Fit label
Bearing preload and wear
Differential bearings support the pinion and carrier and keep the gears in alignment under load. Preload is the set tension on the bearings that keeps the gears meshing correctly, and it is one of the most important settings in a differential rebuild. Too little preload can allow movement, while too much can overheat the bearings and damage the gears.
A worn bearing often shows up as a whine or growl that changes with speed or load, and it can leave metal particles in the gear oil. When replacing a bearing, check the gear pattern and backlash together, since a new bearing can change how the gears sit. Use the same bearing type on both sides and keep the housing clean during installation.
- Check gear oil for metal particles
- Confirm preload and backlash after assembly
Specifications
| Brand | Timken |
|---|---|
| UPC | 68203417285 |
| Type | Specialty differential bearing |
| Quantity | Single bearing |
| Material | Steel |
| Locker spline count | 30 spline |
| Fitment label | Direct Fit |
Vehicle fitment
Fit is set by locker type rather than vehicle, so no year or model is confirmed here. Match the locker type on your differential to the bearing before fitting.
Check the spline count on your locker before fitting. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Use this bearing only with the 30 spline lockers it names. A qualified shop should handle bearing setup and preload on a differential, since incorrect setup can damage gears.
What’s included
1 bearing is included.
Not included: Other differential parts are not included.

















