Overview
The Omix-Ada 16535.40 is a rear axle seal retainer for Dana 35 or Dana 44 axles. One is needed per side. It fits the 2007–2018 Jeep Wrangler (JK).
It is a direct OE replacement built to original specifications.
Key features
- Rear axle seal retainer for Dana 35 or Dana 44 axles
- One needed per side
- Fits 2-door and Unlimited 4-door Wrangler JK
- Omix-Ada part number 16535.40
Seal retainer service tips
The seal retainer holds the axle seal in the housing and keeps lubricant from leaking past the shaft. Leaks often appear as a dark ring of gear oil on the inside of the wheel or on the brake backing plate. A worn retainer or an old seal should be replaced together to avoid a second teardown.
When the axle is open, clean the mounting surface and check the bore for scoring or corrosion. Use a new gasket or sealant as the job calls for, and fill the axle to the correct level after assembly. Check the axle again after the first few drives for seepage at the joint, since a small leak is easier to correct early.
- Clean the housing surface before fitting
- Replace the seal along with the retainer
- Check the fill level after installation
Specifications
| Brand | Omix-Ada |
|---|---|
| Part number | OAI16535.40 |
| Axle | Dana 35 or Dana 44 rear |
| Quantity | One per side |
Vehicle fitment
It fits the 2007–2018 Jeep Wrangler (JK) in 2-door trims (70th and 75th Anniversary, Rubicon, Sahara, Sport and X) and Unlimited 4-door trims (same list).
Wrangler TJ, LJ and JL models are not on this list, and JK years outside 2007–2018 are not covered. Confirm your vehicle’s year, model and trim before ordering.
What’s included
Each axle side needs one retainer.









