Overview
The Daystar D-Ring Isolator KU70057RE is a red polyurethane isolator that snaps onto a standard shackle. It keeps the shackle from tapping against a bumper or other recovery point while the vehicle is moving. It is a universal accessory rather than a part made for one vehicle, and the kit includes four polyurethane washers to reduce D-ring rattle and noise.
The polyurethane body sits between the shackle and the bumper. It also protects the bumper’s finish from scratches caused by D-ring contact. It snaps into place and can be installed or removed in moments.
Key features
- Red polyurethane D-ring isolator
- Snaps into place on a standard shackle
- Stops the shackle from tapping against a bumper or recovery point in motion
- Protects the bumper finish from D-ring scratches
- Kit includes 4 polyurethane washers for rattle and noise
Keeping the D-ring quiet
A shackle that hangs loose against a bumper mount taps with every bump, and over time that contact can wear paint, chip coatings and mark soft trim. An isolator works by placing a cushion between the metal of the shackle and the hard surface it strikes. The result is quieter driving and less wear on the finish around the recovery point.
Inspect the isolator now and then. Look for cuts, cracks or flattened spots in the polyurethane, and replace it once the cushion no longer grips the shackle firmly. Bumpers and recovery points carry the load during a pull, so a worn isolator should be swapped before it is needed. When you reinstall the shackle, make sure it is seated correctly and the pin is secure.
- Look for cuts or cracks in the polyurethane
- Replace the isolator once its grip loosens
Specifications
| Brand | Daystar |
|---|---|
| Part number | KU70057RE |
| UPC | 618089004187 |
| Color | Red |
| Material | Polyurethane |
| Included washers | 4 polyurethane washers |
| Fits | Standard shackle |
Vehicle fitment
This is a universal accessory and is not vehicle-specific. Daystar marks it Universal Fit, so the fit depends on the shackle and recovery point rather than the vehicle.
No year, make or model is named for this isolator. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
The isolator is a snap-on fit with no separate hardware named by Daystar. Check that it is fully seated on the shackle before any recovery pull.
What’s included
One red D-ring isolator and 4 polyurethane washers.
Not included: the shackle and the vehicle recovery point it attaches to.









