Overview
The Dana Spicer Dana 44 Power-Loc Clutches, part 22233X, are replacement clutches for the rear Dana 44 limited slip differential.
The clutches restore the preload a limited slip had from the factory, which helps the unit grip. Clutch setups vary between units, so the clutch count and stack order should match the differential you are rebuilding.
Key features
- Replacement clutches for a Power-Loc limited slip
- Restores factory-level preload
- Rear Dana 44 position
Rebuilding and break-in
Limited slip clutches work by friction, so their condition controls how the unit grips. As clutches wear, the differential slips more under load and may feel uneven during tight turns or on loose ground. A rebuild restores the preload and friction surfaces, so clean and inspect the carrier, side gears and spider gears before reassembly.
Preload is set during assembly, and the clutch count and stack order need to match the unit being rebuilt. Lubricate the clutch packs with the fluid the differential requires, then complete a short break-in so the surfaces seat before heavy use.
- Check the clutch count against the differential before starting
- Inspect side gears and spider gears for wear
- Use the lubricant the differential requires
- Plan a break-in before towing or hard use
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 22233X |
| Axle location | Rear |
| Axle type | Dana 44 |
| Differential type | Limited slip (Power-Loc) |
Vehicle fitment
No vehicle is named for these clutches. Universal fit is shown, but the clutch setup depends on the differential, so match it to the unit you have before ordering.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Clutch packs are set to a preload when the carrier is assembled, so the clutch count and stack order should match the unit you are rebuilding.
What’s included
The clutch pack set for the Power-Loc unit. Count the clutches in the pack against your differential before starting the rebuild.







