Overview
It is a Trac-Loc clutch pack for Dana 35 differentials, for use in either the front or rear location. New clutches restore the preload a Trac-Loc had from the factory, which firms up limited slip action.
Many units use different clutch setups, and a changed clutch arrangement can give a more aggressive lock than stock.
Key features
- Trac-Loc clutch pack for Dana 35 axles
- Front or rear axle location
- Restores preload for firmer limited slip action
- Part number 701046X from Dana Spicer
Clutch stack and preload
A Trac-Loc uses a clutch pack to lock the two axle shafts together under load, so the stack height and preload set how firm the unit feels. Replacing the clutches makes the most sense when the old pack is worn, glazed or uneven, since a tired stack lets the unit spin one wheel more easily. Fresh clutches also make it easier to set preload back to where the unit should be.
Because a changed arrangement can lock harder than stock, keep the original stack order unless the rebuild calls for a change. Measure the stack before assembly and record the readings. Check the gear lash and bearing preload before installing the clutches, since a limited slip can only do its job when the rest of the carrier is set correctly.
- Inspect the clutch plates for glazing and uneven wear
- Keep the stack order recorded during disassembly
- Re-check preload after the first drives
Specifications
| Brand | Dana Spicer |
|---|---|
| Part number | 701046X |
| Axle type | Dana 35 |
| Axle location | Front or rear |
| Differential type | Trac-Loc limited slip |
| Part type | Clutch pack |
Vehicle fitment
This clutch pack is matched to the Dana 35 axle, with no vehicle years, makes or models named. Check that your axle is a Dana 35 and note whether it is the front or rear unit before installing.
Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Preload firms up the lock, so it has to be right after assembly; a shop with differential setup experience is the safer choice.
What’s included
One clutch pack for the Dana 35 Trac-Loc unit, for front or rear location.
Not included: the differential case, spider gears and other rebuild components.








