Overview
The Curt Manufacturing 56262 is a circuit protected powered wiring T-connector for the 2015–2019 Lincoln MKC. It plugs directly into the factory harness and is set up as a 2-wire system, with Curt listing an install time of 40 min.
The 56262 is a circuit protected powered converter. The kit includes a 4 pin connector, a dust cap and a ground wire with a self-tapping screw, and it fits the Lincoln MKC in the Base, Black Label, Premiere, Reserve and Select trims.
Key features
- Circuit protected powered converter
- 2-wire system
- Plugs directly into the factory harness
- 4 pin connector included
- Ground wire with self-tapping screw
- Install time 40 min.
Circuit protection explained
A circuit protected powered converter sits between the vehicle’s wiring and the trailer side, adding protection so a fault in the trailer circuit is less likely to damage the factory harness. That makes it useful on vehicles where trailer load is a concern. Choosing one means matching the wire system to the vehicle and confirming that the trailer lights and brake controller are wired separately.
Because the converter carries power, inspect its connections and housing after each use. Look for heat marks, corroded pins and loose ground screws. A protected circuit that trips often points to a fault elsewhere in the trailer wiring, which should be traced before the converter is reset or replaced.
- Match the wire system to the vehicle before buying
- Inspect the connector after heavy towing
- Trace repeated trips to the trailer wiring
Specifications
| Brand | Curt Manufacturing |
|---|---|
| Part number | CRT56262 |
| Type | Wiring T-connector, circuit protected powered converter |
| Wire system | 2-wire |
| Connector | 4 pin |
| Included | Dust cap, ground wire with self-tapping screw |
| Install time | 40 min. |
| Fitment | Direct fit |
Vehicle fitment
The manufacturer fitment list covers the 2015–2019 Lincoln MKC in the Base, Black Label, Premiere, Reserve and Select trims.
Other Lincoln models are not on this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Route the ground wire to a clean metal point before attaching the self-tapping screw. Allow the full 40 min install time, and disconnect the vehicle battery before working near the factory wiring.
What’s included
A 4 pin connector, a dust cap and a ground wire with a self-tapping screw.
Not included: the factory-fitted MKC harness, which this T-connector taps into.









