Overview
Curt Manufacturing’s 55540 wiring T-connectors, part number CRT55540, are T-shaped connectors for branching trailer wiring. Branching one run into a second circuit is the usual job for a connector of this shape.
The connectors belong to the towing brake controller and electrical group. General wiring parts like these are matched to the trailer’s wire gauge and harness design.
Making a clean branch
A T-connector lets one circuit feed a second device without cutting the main run. The joint is only as good as the crimp or seal at each point, so the main line and branch wires should be stripped cleanly and fully seated in the body before they are secured. Pulled or strained joints are a common failure point on trailer harnesses.
Choose a location where the wire is protected, supported by clips and kept away from road spray. Dielectric grease inside the connector helps keep moisture out, and sealed heat-shrink tubing adds a second layer of protection. After installation, check each branch with a test light or meter and confirm the lights and brakes work before driving away.
- Keep branch wires short and supported
- Use a crimp tool sized for the wire
- Test each circuit before hitching up
Specifications
| Brand | Curt Manufacturing |
|---|---|
| Part number | CRT55540 |
| Product type | Wiring T-connector |
| Fitment | Universal fit |
Vehicle fitment
The fitment entry reads universal, with no particular vehicle attached. T-connectors are general wiring parts, so match them to your trailer’s wire gauge and harness layout. Confirm your vehicle’s year, model and trim before ordering.










