Overview
The Curt Manufacturing 55530 is a 3-wire powered converter T-connector for the 2004–2008 Chrysler Pacifica. It plugs into the factory harness and includes a 4 pin connector, a dust cap and a ground wire with a self tapping screw.
It is a powered converter with a 3-wire system, and the install time is 25 minutes. It fits the 2004–2008 Chrysler Pacifica in Base, LX, Limited and Touring trims.
Key features
- Powered converter with a 3-wire system
- Plugs directly into the factory harness
- Includes 4 pin connector, dust cap and ground wire with self tapping screw
- Install time listed at 25 min.
What a powered converter does
A powered converter changes the signal from the vehicle’s tow wiring so a trailer’s lights can work with it. The 3-wire design includes power pathways that a 2-wire system does not, which is why converter type matters when matching a connector to a trailer. Check your trailer’s lights before buying anything.
When installing, connect the plug firmly and confirm it seats fully. Use the included ground wire with its self-tapping screw on a clean metal point so the ground stays solid. Poor grounding is one of the most common causes of dim or flickering lights on a converter setup.
Inspect the connector and wiring after every few trips, especially in wet or salty conditions. Look for cracked insulation, green corrosion on the pins and loose terminals. Replace parts that show damage rather than trying to repair them, since a weak connection can produce intermittent trailer lighting that is hard to trace.
Specifications
| Brand | Curt Manufacturing |
|---|---|
| Part number | CRT55530 |
| Converter type | Powered converter |
| Wiring system | 3-wire |
| Connector | 4 pin |
| Install time | 25 min. |
| Fitment type | Direct fit |
Vehicle fitment
Curt’s manufacturer fitment list covers the 2004–2008 Chrysler Pacifica in Base, LX, Limited and Touring trims.
Other Chrysler models and Pacifica years outside 2004–2008 are not in this list. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Curt lists 25 min. for installation of this powered 3-wire model. Connect the 4 pin connector to the factory harness and secure the ground wire with the included self tapping screw.
What’s included
A 4 pin connector, a dust cap, and a ground wire with a self tapping screw.
