Overview
These are a pair of D.O.T. approved stainless braided extended rear brake lines from the RockJock JK suspension system, for the 2007–2018 Jeep Wrangler (JK), 2-door and 4-door. They are for use with a rear Antirock sway bar kit only.
Key features
- D.O.T. approved stainless braided extended brake lines
- Only for use with a rear Antirock sway bar kit
- Supplied as a pair
- Four copper banjo bolt washers
- Frame tabs and clips included
- For 4 to 6 inch lifted vehicles
Routing and replacing brake lines
Extended brake lines need enough length to reach the new rear sway bar and axle position without stretching when the suspension compresses. Route them away from sharp edges, exhaust heat and moving parts, and use the frame tabs and clips to hold them in position. Check that the lines stay clear through full suspension travel.
Braided lines should be inspected at regular intervals for chafing at the clips and for leaks at the fittings. Replace the copper banjo washers each time a banjo fitting is disconnected, since reused washers can seep. After any line replacement, bleed the brakes and test the pedal before driving.
- Route lines clear of exhaust and sharp edges
- Check clearance through full suspension travel
- Replace copper banjo washers after disconnecting
- Bleed the brakes after any line change
Specifications
| Brand | Currie |
|---|---|
| Part number | CE-9807RBLK |
| UPC | 70000498043 |
| Position | Rear |
| Type | Stainless steel braided |
| Quantity | Pair (two hoses) |
| Hose length | 23.5 inch or 25.5 inch; confirm the length against your lift before ordering |
| Lift range | 4 inches to 6 inches |
| Length class | Lifted |
| Fit | Direct fit |
| Hardware | 4 copper banjo bolt washers, frame tabs, clips |
Vehicle fitment
The kit is made for the 2007–2018 Jeep Wrangler (JK), 2-door and 4-door models.
It is not for TJ or YJ Wranglers. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
Use this kit only when a rear Antirock sway bar kit is installed. If the stock rear sway bar stays, Currie says you need the CE-9807FBLK line kit instead.
What’s included
Two stainless braided hoses, 4 copper banjo bolt washers, frame tabs and clips.








