Overview
The Currie CE-9110P is a 2-1/2 inch weld-on Johnny Joint for fabricators and suspension builders making their own control arms. It is a universal part rather than one designed for a specific vehicle, and it has to be welded into the arm or bracket.
The joint moves 30 degrees freely in any direction, compared with 22 degrees for a common heim joint. The urethane bushing encases the inner ball and is designed for durability and weather resistance. The center ball is heat-treated steel with a 9/16 inch thru-bolt hole and cross-drilling for thru-bolt lubrication.
Key features
- Weld-on design for fabricated arms and brackets
- Urethane bushings in a high-density formulation Currie calls tough 88
- Heat-treated steel center ball, cross-drilled for thru-bolt lubrication
- 9/16 inch thru-bolt hole
- Outer shell of .180 inch DOM tubing
- Heat-treated steel retaining washers
- Fully rebuildable
Weld-on fabrication tips
Weld-on joints are only as strong as the weld and the bracket around them, so fabrication quality matters more than the joint itself. Prepare the bracket or arm by cleaning mill scale and paint from the weld area, and fit the joint square before tacking it in place. Check the thread and bore alignment, since a joint welded at an angle changes how the arm loads.
After welding, allow the joint to cool without quenching it, then grease the joint if the design allows it and recheck the arm’s movement. Inspect the welds after the first few drives for cracks, and look at the joint for play or wear. A joint that shows movement at the weld should be repaired by a qualified welder before the arm is used hard.
Specifications
| Brand | Currie |
|---|---|
| Part number | CE-9110P |
| UPC | 70000223807 |
| Mounting type | Weld-on |
| Outside diameter | 2-1/2 inch |
| Mounting width | 2.625 inch |
| Thru-bolt hole | 9/16 inch |
| Bushings | Urethane, tough 88 formulation |
| Center ball | Heat-treated steel |
| Outer shell | .180 inch DOM tubing |
| Retaining washers | Heat-treated steel |
| Serviceability | Fully rebuildable |
Vehicle fitment
It has no vehicle fitment and is intended for universal use in custom arms and fabricated suspension.
Check the 2.625 inch mounting width and 9/16 inch bolt size against your bracket before welding. Confirm your vehicle’s year, model and trim before ordering.
Installation notes
This joint is weld-on, so it is welded into the arm or bracket rather than bolted. Plan the weld position before you set the joint, and use a qualified welder for the work.
What’s included
One weld-on Johnny Joint rod end with urethane bushings and a 9/16 inch thru-bolt hole.
Not included: the bolt and nut (part number CURCE-91107), and the mounting bracket or arm the joint is welded into.









