Overview
The Crown Automotive 4004816K is a spindle nut and washer kit for the front Dana 44 axle. It covers one side only and includes two nuts and one washer. It fits the 1974–1988 Jeep J10 and J20 trucks.
Because the kit covers one side, a truck with both front spindles needs a kit for each side. The kit is made for the Dana 44 front axle and does not fit other Dana axles.
Key features
- For the front Dana 44 axle only
- Covers one side only
- Includes 2 nuts and 1 washer
Spindle service tips
The spindle nut and washer hold the hub assembly in place on the front Dana 44 axle, so they need to be tight and in good condition. Inspect the threads and the washer surface whenever the hub is removed. Corroded or stretched threads can allow the nut to loosen, so replace worn nuts rather than trying to reuse them.
When both sides are being serviced, work through them in matched pairs so that each side receives the same parts and checks. Clean the spindle and hub surfaces before reassembly, and keep the nut and washer orientation the same as the original. Recheck the nut after the first drives, since fresh parts can settle as they seat.
- Inspect threads for damage before reuse
- Check hub bearing adjustment after reassembly
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | 4004816K |
| Axle | Dana 44 front |
| Coverage | One side |
| Contents | 2 nuts and 1 washer |
| Position | Front |
Vehicle fitment
It fits the 1974–1988 Jeep J10 and the 1974–1988 Jeep J20. Other Jeep models and other Dana axles are not covered. Confirm your vehicle’s year, model and trim before ordering.
Only Dana 44 front axles are covered. Confirm the axle type before ordering.
Installation notes
Order one kit for each side that needs the spindle nut and washer. The kit covers one side only, so a truck with both sides serviced needs two.
What’s included
Two nuts and one washer, for one side only.









