Overview
The Crown Automotive A556 is a power brake master cylinder for the 1946–1948 Jeep Willys CJ-2 and the 1941–1942 Willys MB. It is a replacement-type unit that retains the factory mounting hardware, so the original fasteners carry over.
It is a direct-fit design for a disc/drum brake setup.
Key features
- Power brake master cylinder
- Replacement type, direct fit
- Retains factory mounting hardware
- Fits disc/drum brake configuration
Power brake system basics
A master cylinder converts pedal force into hydraulic pressure for the wheel cylinders or calipers. On a power brake system, the booster multiplies the pedal force before it reaches the cylinder, so the cylinder works with higher loads than on a manual system. Matching the cylinder to the booster and the brake layout keeps pedal feel predictable.
Before fitting a new cylinder, check the booster pushrod length and the condition of the brake lines. Old fluid and air can remain in the circuit after a swap, so the system needs to be bled in the correct order. Use fresh brake fluid of the type the system calls for, and keep the reservoir topped up during the process.
- Check the pushrod and booster mounting before fitting
- Inspect brake lines for corrosion near the cylinder fittings
- Bleed the system at each wheel after installation
- Test the pedal before moving the vehicle
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | A556 |
| UPC | 848399050257 |
| Part type | Power brake master cylinder |
| Type | Replacement |
| Fit style | Direct fit |
| Brake configuration | Disc/drum |
Vehicle fitment
It fits the 1946–1948 Jeep Willys CJ-2 and the 1941–1942 Willys MB.
It does not fit later CJ-3, CJ-5 or CJ-7 models. Confirm fit for your vehicle’s year, model and trim before ordering.
Installation notes
The A556 keeps the factory mounting hardware, so the existing bolts and brackets on the vehicle are reused.









