Overview
The Crown Automotive J0274428 is a castle nut that works with both tie rod ends and the pitman arm. Crown Automotive makes replacement parts for Jeep vehicles, and this nut is one of them.
It is a single castle nut with UPC 848399051575. It is the nut itself, not a tie rod end or pitman arm.
Key features
- Works for both tie rod ends and the pitman arm
- Castle nut design
- Replacement part from Crown Automotive for Jeep vehicles
Castle nut torque and locking
A castle nut is slotted so a cotter pin can pass through the stud and lock the nut in place. That locking method matters on steering joints, where vibration and load can back off an unsecured nut. The nut is only one part of the joint, so the stud threads, the taper and the cotter pin hole should be checked together before tightening.
Tighten in steps rather than all at once, then advance the nut to the next slot so the pin hole lines up. Do not back the nut off to align the hole unless the torque is rechecked afterward. Replace any nut with stripped threads or a damaged slot, since a worn castle nut can loosen even when the pin is installed.
- Inspect stud threads for damage before fitting
- Use a new cotter pin when the nut is removed
- Advance the nut to align the slot instead of loosening it
- Recheck fasteners after the first few drives
Specifications
| Brand | Crown Automotive |
|---|---|
| Part number | J0274428 |
| UPC | 848399051575 |
| Type | Castle nut |
| Used on | Tie rod ends and pitman arm |
| Fitment | Direct fit, no vehicle named |
Vehicle fitment
No vehicle years, models or trims are named for this castle nut. Crown lists direct fit without naming a vehicle, so match the nut to the stud on your tie rod end or pitman arm.
Confirm your vehicle’s year, model and trim before ordering.
What’s included
One castle nut. Not included: The castle nut ships alone, without a cotter pin.









